Filter
Top Products
Setting the Alarms
1. Press and hold the or Button until the alarm icon and alarm time blink. Press the or Button to set the
alarm time. Holding the button for a few seconds will advance or reverse rapidly.
Remember to set the correct AM or PM time.
2. Press the Wake-to Button to select iPod or Buzzer alarm source. You can set different alarm sources for each alarm.
The wake to icon will blink for 5 seconds, followed by the alarm icon and time.
3. Press the Alarm Button again or wait for 5 seconds. Alarm is now armed, indicated by the numbered alarm clock icon.
Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)
1. Press the or Button once. The unit will show the alarm time on the bottom part of the display for alarm time review.
2. During alarm review, press the or button again to arm or disarm the alarm. When the alarm is armed, the related
alarm icon appears in display.
Resetting the Alarm to Come on the Next Day
1. When the alarm is sounding, press the Button to stop the alarm and reset it to come on the following day at the
same time.
Snooze
1. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes
later. Snooze can be press several times during the 1 hour alarm cycle.
Sure Alarm
The iH120 has a sure alarm feature. If backup batteries are installed (see page 3) the buzzer alarm will still sound in the event
of a power failure.
6
Using the Alarms
Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert) and that it is properly docked
into the iH120. Failure to do so may damage your iPod.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Note that
non-docking iPods will NOT charge.
Charging your iPod