Filter
Top Products
Additional information for units sold in
Great Britain:
Units sold in GB are suitable for operation from a
240 V AC, 50/60 Hz mains supply.
Mains plug
This apparatus is fitted with an approved moulded
13 Amp plug.
To change a fuse in this type of plug proceed as
follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5
AMP, A.S.T.A. or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should have
a value of 5 A. If a plug without a fuse is used, the
fuse at the distribution board should not be
greater than 5 A.
Note: The severed plug must be disposed to
avoid a possible shock hazard should it be
inserted into a 13 A socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in
accordance with the following code: blue = neutral
(N), brown = live (L). As these colours may not
correspond with the colour markings identifying
the terminals in your plug, proceed as follows:
1 Connect the blue wire to the terminal marked N
or coloured blue or black.
2 Connect the brown wire to the terminal marked
L or coloured brown or red.
3 Do not connect either wire to the earth terminal
in the plug, marked E or e or coloured green or
green-and-yellow.
Before replacing the plug cover, make certain that
the cord grip is clamped over the sheath of the
lead - not simply over the two wires.
If in doubt, consult a qualified electrician.
SC 910 page 2
INDEX
2
Deutsch.....................
Seite 4
D
English.....................
page 11
GB
Français .................page 18 F
Italiano .................
pagina 25
I
Português .............
página 32
P
Español .................
página 39
E
Nederlands...........
pagina 46
NL
Dansk........................
side 53
DK
Svenska....................
sida 60
S
Suomi........................
sivu 67
FIN