Grizzly G9861 MP3 Docking Station User Manual


 
-12- Ultimate Series Jointers
Cutterhead Guard
The cutterhead guard spring tension comes pre-
set from the factory. To install the cutterhead
guard:
1. Loosen the black plastic knob shown in
Figure 6.
2. Slide the cutterhead assembly post into the
slot shown in Figure 6.
3. Tighten the black plastic knob that was loos-
ened in Step 1.
4. When rotated, make sure the cutterhead
guard rotates back over the cutterhead
assembly.
Figure 4. Properly installed key.
Figure 5. Fence base lock knob attachment.
Figure 6a. Attaching cutterhead guard.
3. Carefully lift the fence assembly onto the
fence base support. Make sure that the key is
fully seated into the key way. Avoid letting the
fence slide across the jointer tables.
4. Slide the lock handle shaft through the flat
washer and into the slot on the top of the
fence assembly base. Thread the slide piece
onto the end of the lock knob shaft as shown
in Figure 5.
5. Thread the fence adjustment handle into the
tapped hole on the top edge of the fence.
6. With the lock knob loose, the fence assembly
should slide smoothly across the key way.
Avoid letting the fence drag across the tables.
Installed Key