Filter
Top Products
make sure an iPod is not docked
in the iBlaster Clock Radio.
Plug one end of the audio
patch cord (included) into the
headphone or LINE-OUT jack on
your device and the other end of
the patch cord into the iBlaster
Clock Radio LINE-IN jack, locat-
ed on the back of the unit.
Press the iPod button on the
iBlaster Clock Radio (or
PLAY/PAUSE button on the
remote). The AUX icon will
appear, indicating AUX playing
mode.
Turn on and play your device.
Use the VOLUME knob on the
left side of the unit to adjust the
volume.
To turn OFF the unit, press the
ALARM RESET/POWER OFF but-
ton (or the POWER ON/OFF but-
ton on the remote). Be sure to
turn off your device as well.
Listening to Radio
To listen to the radio, first
fully extend the FM antenna wire
to improve reception.
NOTE: Do not strip, alter or
attach to other antennas. The
AM antenna loop should be
placed up to 12 inches away
from the unit for best reception.
You can also rotate the AM
antenna loop to improve recep-
tion.
To listen to the radio, first
press the RADIO button on the
iBlaster Clock Radio or on the
remote control. The radio fre-
quency will appear on the top
right corner of the display.
Press the AM/FM button on the
iBlaster Clock Radio or on the
remote control to select AM or
FM radio stations.
Turn the SETTINGS knob on
the iBlaster Clock Radio or the
>> or << button on the remote
control to find your desired sta-
tion.
Turn the VOLUME knob on the
iBlaster Clock Radio or the
VOL+ or VOL- buttons on the
remote control to adjust the VOL-
UME.
To turn the radio OFF, press
the ALARM RESET/POWER OFF
button on the iBlaster Clock
Radio or the POWER ON/OFF but-
ton on the remote control.
Connecting your iBlaster
Clock Radio to external
equipment
You can connect the iBlaster
Clock Radio to another line-
level device, such as an amplifi-
er or recording device through
the LINE-OUT jack located at the
back of the unit. The VOLUME
setting on the iBlaster Clock
Radio does not affect the line
level. Adjust the VOLUME
through the device you connect
to.
You can connect your iBlaster
Clock Radio to your television
by using the OUTPUT terminals
on the back of the unit. Before
connecting, be sure to set your
iPod video to television. The
OUTPUT terminals output the
video and audio signals shown
on the television.
If your television has an
S-VIDEO INPUT terminal, connect
your iBlaster Clock Radio to it.
If not, connect it to the video
terminal, as shown in Figure 9.
Figure 9: Connecting your iBlaster Clock Radio to external equipment
12
13