Filter
Top Products
9
OPERATING INSTRUCTIONS
• Make sure you have installed the batteries in the battery compartment, or
• Connect the AC power cord plug to a 120V 60Hz AC outlet.
GENERAL CONTROLS
BASS BOOST ON /OFF Button
Set this button to the ‘ON ’ position to increase the bass response. Set to the
‘OFF ’ position for normal bass response.
FM MODE Selector
Normally you should leave this switch set to the “ST ” position for FM Stereo
reception. However if you are listening to a distant FM Stereo station and the
reception is noisy or weak set this switch to the ‘MONO ’ position. This will
normally provide some improvement in reception, however the sound will no longer
be in stereo.
LISTENING TO THE RADIO
1.) Slide the POWER OFF/CD/RADIO selector switch, located on the top cabinet,
to the RADIO position. The Power indicator will light.
2.) Select the desired band – AM or FM – by sliding the BAND selector, located
on the right side, to the correct position.
3.) Fully extend the telescoping FM rod antenna.
4.) Set the FM MODE button to the Stereo “ST ” position.
5.) Tune to the desired station by slowly rotating the TUNING control on the right
side. If you tune to an FM Stereo station the FM ST indicator will light.
6.) Rotate the VOLUME control to adjust the volume to the desired level.
7.) Set the BASS BOOST switch to the “ST ” position to increase the bass
response if desired.
8.) When you are finished listening slide the POWER OFF/CD/RADIO selector
switch back to the POWER OFF position. The Power indicator goes off.
SB250_251_ib071703.p65 17/7/2003, 14:279