Filter
Top Products
SAFEGUARD AGAINST ACCIDENTAL ERASURE
When a new recording is made, any program
material previously recorded is automatically
erased and only the new recording remains. To
safeguard valuable recordings from being erased
accidentally, the cassette and the deck are
equipped with a special device.
On the back of the cassette there is an erase
prevention tab on each side. To prevent
accidental erasing, break out these tabs with a
screwdriver. If only one side of the tape is to be
protected, break out the tab on the left side with
the side desired facing you.
To record on a tape in which the tab has been
broken, place a piece of adhesive tape over that
area.
NOTE: When a tab is broken out, the record
button cannot be depressed.
CASSETTE TAPE RECOMMENDATIONS
Standard tape lengths have 15 (C-30), 30 (C-60) and 45 (C-90) minutes of recording time on each side.
Longer length tapes of 60 (C-120) minutes of recording time on each side are not recommended. Use only
high quality tapes. If a problem develops, check the unit first with another cassette to determine if the
problem is with the cassette, and not with the unit.
If there is any slack in the tape in the cassette, it should be removed before inserting the cassette. Place a
pencil in one of the hubs and rotate clockwise until all slack is taken up.
15
CASSETTE TAPES
Tab
Cover with tape to record again
Break out the tab
to prevent recording
SIDE 1
Tab for side 1
Tab for side 2