Filter
Top Products
16
PROGRAMMED PLAYBACK
You can program up to 20 tracks on a disc to play in any desired order.
NOTE: You cannot program a disc during playback. If the disc is playing press
the STOP button first to stop playback and then follow the programming steps
below.
1.) While the total tracks and playing time appear
on the display press the PROG button once.
The PROG indicator and the Program Number
(P – 01) appear, and the track number (000) flashes.
2.) Press the SKIP FWD or SKIP REV button to
select the first track to be programmed.
Example: Track 002.
3.) When the desired track number is flashing in
the display press the PROG button again to
enter the desired track number in Program
Number 01. The track number returns to “000”
and the Program Number advances to “P – 02”.
4.) Repeat Steps 2 and 3 to program additional tracks up to a maximum of 20.
5.) Press the PLAY/PAUSE button to begin
programmed playback. The PROG indicator
remains in the display and the track display
stops flashing.
Playback begins with the first track you programmed and continues until all
programmed tracks have been played, and then the player stops. The
programmed sequence will remain in the memory until the power shuts off
(approximately 20 seconds) or until the CD door is opened. If you press the
PLAY/PAUSE button again before the power shuts off the programmed
sequence will play again.
STOP
STOP
STOP
PLAY
HD7295_052404.p65 24/5/2004, 18:0916