Filter
Top Products
21
Resetting The Clock After A Total Memory Loss
If you do not change the built in lithium battery within a reasonable period of time
after you see the warning indicator, the lithium battery may become exhausted
and will no longer be able to supply back up power to the SmartSet
®
internal
computer. If the unit is disconnected from the AC outlet after the battery is exhausted,
or if a power interruption occurs, the SmartSet
®
memory will be lost and the clock
will need to be reset when the power is restored. Be sure to install a fresh lithium
battery before you reset the clock, otherwise the clock will need to be reset each
time the power is interrupted.
If the lithium battery is exhausted and you experience an interruption in the AC
power supply, the clock will reset itself to its initial default setting when the power is
restored.
The initial default setting is 12:00 AM,
SATurday, January 1st (1.01), 2005.
If you notice that the time on your SmartSet
®
clock radio is completely incorrect,
and the DAY OF WEEK indicator is also wrong, press the CALENDAR button. If
the small displays are showing “1.01” and “2005”, you probably experienced a total
memory loss. To reset the clock after a total memory loss, proceed as follows:
1.) Follow the instructions on page 19 and install a new CR2430 lithium battery in
the battery compartment.
2.) Connect the radio to your AC outlet and let the clock set itself.
3.) Depress the CALENDAR button. The ALARM displays will change to “Month.
Date” and “Year”.
• While holding the CALENDAR and TIME buttons, press the SET (Up) button
to set the ALARM 2 display to the correct year, then release the buttons.
• While holding the CALENDAR button, press the SET (Up) button to set the
ALARM 1 display to the correct “Month” and “Date”. When the correct month
and date appear on the display, release the buttons.
• The DAY OF WEEK indicator will change automatically as you adjust the “Year”,
“Month/Date” settings.
CKS3020_072706.p65 27/7/2006, 11:3521