Emerson CKS2288 Clock Radio User Manual


 
13
CHANGING THE LITHIUM BATTERY
Like all batteries, eventually the built in lithium battery will need to be replaced. A
number of factors, such as, the length of time between the date the radio was
manufactured and the date you plugged it in for the first time determine the amount
of time before replacement. During this initial storage period, the lithium battery is
supplying power to the SmartSet
®
computer memory. Once you plug the radio in,
your household outlet supplies the power, and the battery is not being used. A
fresh lithium battery can supply power to the SmartSet
®
computer for at least 3
years even if it is never connected to an AC power supply. If your radio was
connected to your AC supply within a few months after it was manufactured, and
you experience only the normal, nuisance type, short duration power interruptions,
your battery may last for up to 5 years or even longer.
When the battery power drops below a certain level, the BATT. LOW indicator
will come on. When you see this indicator, you should change the battery as soon
as it is convenient for you to do so. To change the battery proceed as follows:
1.) Purchase a replacement 3V lithium battery wherever batteries are sold. The
battery type is CR2430 or equivalent.
2.) Remove the battery from its package so it is ready to install.
3.) Important: Leave the radio power cord connected to your AC outlet. This will
provide power to the SmartSet
®
computer memory while the original lithium
battery is removed.
4.) Place the radio face down and use a small screw driver to remove the screw
securing the battery holder to the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW !
5.) Slide the battery holder out of the cabinet. Then remove the original battery
from the holder and insert the
new battery into the holder the
same way, with the positive(+)
side facing up.
6.) Slide the holder with the new
battery back into the opening in
the cabinet.
7.) Replace the screw that secures
the battery holder in the cabinet.
8.) Place the radio standing up and
confirm that the BATT. LOW
indicator is Off.
9.) Save these instructions.
Youll have to do this again five to eight years from now!
NEGATIVE(–) SIDE
POSITIVE(+) SIDE
CKS2288_ib_092302.p65 23/9/2002, 11:5313