Filter
Top Products
16
Alarm Operation
Setting the ALARM Time (Wake Up time)
This clock radio has two separate wake-up
alarms that can be set and used independently.
To set or adjust the wake-up times please proceed as follows:
Check the Alarm Time : During CD playing or radio listening, press ALARM
1/ ALARM2 buttons to show alarm time in display.
Alarm time setting: Press the POWER button to off mode, hold the ALARM 1/
ALARM2 buttons and then press either
the buttons to adjust alarm time
forward and backward as desired. Each press of the buttons will
change the display time by one minute. If you hold the buttons the
display time will change slowly at the first, but if you continue holding the
buttons the display digit will change
rapidly.
NOTE: If Alarm 1 and Alarm 2 are set in same alarm time, only Alarm 1 will
sound.
Activate or Deactivate the Wake-up Mode
After you have adjusted the wake-up times on one or both alarms, you must
activate the alarms and select the wake-up mode. You have the option of waking
to the buzzer, radio or CD.
Setting the Wake Up Mode: Press the POWER button to off mode, hold the
ALARM 1/ ALARM2 buttons and press the ALARM SET / DISPLAY button to
select the wake-up mode. Once the wake up mode is activated the AL1 or
AL2 indicator will light on the display.
Wake to Radio : Select a radio station and make sure the volume is set as
desired. Press the POWER button to off mode, hold the ALARM 1/ ALARM2
buttons and press the ALARM SET / DISPLAY button until the AL1 or AL2
indicator turns red.
Wake to CD : Place a CD in the CD compartment and make sure the volume
is set as desired. Press the POWER button to off mode, hold the ALARM 1/
ALARM2 buttons and press the ALARM SET / DISPLAY button until the
AL1 or AL2 indicator turns green.
NOTE: If there is no CD inserted, or the CD is damaged, it will automatically
wake to Buzzer.
AL2
MON
TUE
WED
THU
FRI SAT
SUN
AL1
AM
SAT
or
or
or
or
Wake to Buzzer : Press the POWER button to off mode, hold the ALARM 1/
ALARM2 buttons and press the ALARM SET / DISPLAY button until the
AL1 or AL2 indicator turns amber.