Filter
Top Products
11
Listening To The Radio
1.) Press the POWER button to turn the unit
‘On’. The POWER indicator comes ‘on’.
2.) Set the FUNCTION selector (on left side panel) to RADIO position.
Set the BAND selector (on right side panel) to FM ST. or AM.
3.) Turn the TUNING control to find the desired
station. If you tune to a FM Stereo station
the FM STEREO indicator light comes ‘On’.
4.) Adjust the VOLUME control to the desired level.
5.) When you are finished listening press the POWER button to turn the unit ‘Off’.
The POWER indicator goes off.
Antenna Information
AM
The AM ferrite bar antenna is inside
the cabinet. If AM reception is
unsatisfactory try turning the entire
unit slightly until you find the
direction that provides the best
reception for the desired station.
FM
Make sure the FM lead wire antenna is
extended to it’s full length. You may have
to vary the direction of the wire antenna
to find the position that provides the best
reception.
ALM 2
ALM 1
PM
REPEATPROGRAM RANDOM POWER
FM STEREO
ALM 2
ALM 1
PM
CKD9902_041707.p65 17/4/2007, 11:0511