Filter
Top Products
7
OPERATING INSTRUCTIONS
SETTING THE CLOCK
When you connect the radio to your AC outlet for the first time the clock display will
begin flashing “12:00” (AM). The flashing will stop when you set the time.
1. Depress the Clock button and the Fast Forward button and advance the
display to a few minutes ahead of the correct time.
2. Release the Fast Forward button and depress Slow Reverse button
until the correct time appears, then release all buttons.
Note: Be sure to observe the AM indicator to make sure that the time is set correctly
for AM or PM. If the AM indicator is ‘on’, the time displayed is “AM”. If the AM
indicator is ‘off’, the time displayed is “PM”.
SETTING THE WAKE UP TIMES
This clock radio has two separate alarms that can be set and used independently.
You may use the alarms to wake two people at different times, or you may use one
alarm for weekdays and the other for weekend wake up times. The procedure for
adjusting the wake up time is the same for both Alarm 1 and Alarm 2.
1. Depress and hold either the Alarm 1 or Alarm 2 setting button. The display will
change from the correct time to the Alarm 1 or Alarm 2 wake up time.
2. While holding the Alarm 1 or Alarm 2 setting button, depress the Fast Forward
button to advance the display to a few minutes ahead of the desired wake up
time.
3. Release the Fast Forward button and depress the Slow Reverse button
until the desired wake up time appears, then release all buttons.
Note: Be sure that you have set the wake up time correctly by observing the AM
indicator. If the AM indicator is ‘on’ the wake up time is “AM”. If the AM
indicator is ‘off’, the wake up time is “PM”.
AM indicator
ALARM 1 indicator
ALARM 2 indicator
CK5051_ib_Rev.p65 17/12/2001, 10:517