Filter
Top Products
3
PREPARATION FOR USE
UNPACKING AND SET UP
• Remove all packing materials from the unit. Also remove any descriptive labels
from the front or top of the radio. Do not remove any labels from the back or
bottom of the radio.
• Place the radio on a stable shelf, desk, nightstand, table, etc, convenient to a
110V 60Hz AC outlet, and away from direct sunlight or sources of heat, humidity,
moisture, dust, or vibration.
• Unwind the AC power cord. The FM antenna is built into the power cord so be
sure to extend it to its full length for best FM reception.
BACK UP BATTERY INSTALLATION
The Back Up battery compartment is located on the bottom of the radio. Open the
battery door, as shown in the illustration, and connect a 9V battery (not included)
to the battery terminals. The battery can only be connected one way. Push the
battery back into the battery compartment and replace the battery door.
Note: Use only a well known brand of Alkaline battery for longest life and best
performance.
In the event of a temporary power interruption the clock display will go off, but the
back up battery will maintain the time and alarm settings. When power is restored
the clock display will come on again and the time and alarm settings will be correct.
POWER FAILURE INDICATION
If you do not install a battery, or if the battery is exhausted and the power is
interrupted, the time and alarm settings will be lost. When power is restored the
display will begin flashing. This flashing display is your indication that the clock is
incorrect and you must reset both the time and alarm settings.
9
V
O
L
T
Press