Filter
Top Products
Intended for situations where very high SPL
and maximum throw are desired, the PX2122 packs tremendous horsepower. Dual ND2 com-
pression drivers are precisely summed in a manifold configuration for increased power handling,
maximum high and mid frequency headroom, and lower distortion. Designed to reproduce the
frequency range above 80 Hz, the PX2122 works perfectly with the PX2181 subwoofer.
The tight coverage of the low distortion 45° x 30° rotate-able horn gives the PX2122 excellent
array characteristics. An integral 15° per side trapezoidal design allows arraying up to three wide,
with a recommended minimum of two per side. In an effort to simplify setup, PX2122 cabinets can
be securely splayed within the safety grooves routed into the PX2181 subwoofer, reducing the
need for straps and eliminating speaker cluster guesswork.
Dual high-efficiency, forced-air cooled DVX3121 12-inch woofers compliment the high perfor-
mance manifold section of the PX2122. With an overall broadband sensitivity of 102dB and “bi-
amp only” architecture, the PX2122 is ready to be utilized to its maximum high power potential.
The PX2122 employs rugged EVCOAT® covering and 18-mm, 13-ply plywood with complex
tongue-in-groove construction for long-term strength and consistency. Handles on the top, bottom
and both sides make transport easy, while eight M10 points provide flexibility in situations where
hanging is either necessary or optimal.
accessory:
Optional PX-D1 wheel kit for PX2122 and PX2152 rotates to a horizontal position for rolling and a vertical position
when forming arrays, eliminating the need to remove and store the PX-D1 during use.