Filter
Top Products
MISCELLANEOUS INFORMATION
39
TX INHIB - Indicates that the selected group is temporarily busy. This
message is not displayed in the conventional mode.
SYN ERR - Indicates a frequency synthesizer error. Refer to “Trans-
ceiver Service” on page 42.
PRG ERR - Indicates that no transmit frequency has been programmed
for the selected system. Refer to “Transceiver Service” on page 42.
RX PRI1 - Indicates that a call has been received on the first priority
group (see “Priority Calls” on page 27). Press any key except backlight to
turn it off. This message is not displayed in the conventional mode.
RX PRI2 - Indicates that a call has been received on the second priority
group (see preceding description).
IN SCAN - Indicates that system scanning is occurring.
KEYLOCK - Indicates that the keypad has been disabled by turning
power on with the LCK key pressed. Turn power on again with this key
pressed to re-enable the keypad.
Rechargeable Battery Pack
WARNING
Dispose of the nickel-cadmium battery pack in accordance with local
regulations. Do not dispose in fire because it may explode.
Battery Pack
NOTE: Before removing a battery pack, make sure that transceiver power
is turned off.
With proper care, a battery pack should provide many months of
service. Since the battery pack is a sealed unit, it cannot be serviced and
must be replaced whenever it fails to hold a charge or is defective for
some other reason. To remove the pack, press the spring-loaded button on