Filter
Top Products
SPECIFICATIONS JFX100
DIMENSIONAL DRAWING
INPUT PANEL
A & E SPECIFICATIONS
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 info@eaw.com www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. JFX100/0004638/2 pp September 2002 Printed in USA
Manufacturing tolerances are +/- 0.13 and +/- 1°
1.71
INPUT
C
L
0001755 (A) 8/26/02
C
2X 5.00
4.00
L
C
8.21
4.75
C
L
45°22.5°
LEFT SIDE
4.25
FRONT
5.29
5.75
RIGHT SIDE
11.68
BOTTOM
11.82
TOP
5.29
GRILLE PARTIALLY SHOWN
TOP HAT
2.94
19.75
9.50
HANDLE
1.59
BACK
NOTES:
1. SYMBOL INDICATES MOUNTING POINT,
5/16-18 T-NUT FOR OMNI MOUNT SERIES 100.
2. SYMBOL INDICATES 3.00 X 1.35 FLY TRACK.
3. SYMBOL INDICATES CENTER OF BALANCE.
4. WEIGHT APPROX. 39 LBS.
5. SHIPPING WEIGHT APPROX. 43 LBS.
L
3.13
4.94
3.00
3.38
2X 2.75
The 2-way full-range loudspeaker shall incorporate a 10-in LF
cone and a 1.75-in voice coil neodymium HF compression
driver. The LF cone shall be mounted in a vented enclosure
tuned for optimum low frequency response. The HF driver
shall be loaded on an axis-symmetrical, 1-in exit Wave Guide
Plate™ with a nominal conical beamwidth of 100 degrees. An
internal passive filter network shall provide all acoustical
crossover and system equalization requirements.
System frequency response shall vary no more than +
3 dB
from 90 Hz to 16 kHz measured on axis. The loudspeaker shall
produce a sound pressure level of 96 dB SPL on axis at 1
meter with a power input of 1 watt, and shall be capable of
producing a peak output of 127 dB SPL on axis at 1 meter. It
shall handle 300 watts of amplifier power and shall have a
nominal impedance of 8 ohms.
The loudspeaker enclosure shall be irregularly trapezoidal in
shape. It shall be constructed of exterior grade Baltic birch
plywood and shall employ extensive internal bracing. It shall
be finished in wear-resistant textured black paint. Input con-
nectors shall be 2x Neutrik NL4 Speakon wired in parallel. It
shall include a pole mount cup and a handle integral to the
rear of the enclosure. One 3-postion fly track with an integral
3/8"-16 threaded mounting/suspension point shall be provid-
ed on the top of the enclosure. Four 5/16"-18 threaded
mounting points for use with an Omnimount® Series 100 (or
similar) and a pull-back ring shall be provided on the rear of
the enclosure. The front of the loudspeaker shall be covered
with a foam backed, powder coated perforated steel grille.
The 2-way full-range loudspeaker shall be the EAW model
JFX100.
WHITINSVILLE, MA USA
JFX100
PIN 1--...--
PIN 1+...+
PIN 2--...NC
PIN 2+...NC
S/N