Filter
Top Products
INSTALLING THE SPEAKER
Step 1: Determine where the speaker will be mounted. Make sure there is a flat
area large enough for the speaker to fit properly. An uneven mounting
surface can damage the driver and limit the bass performance of your PC
component system.
Step 2: Check to make sure the mounting location you have chosen for the
speaker will not interfere with the operation of the vehicle.
Step 3: Using the supplied template guide, mark the hole with a pen.
Step 4: [Skip this step if using correctly sized factory locations] Cut the hole for the
speaker. A hole can be cut either with a pair of metal tin snips, razor knife, air
saw, or with a hole saw corresponding to the size of the woofer listed below.
• 4-3/4” Hole Saw (5-1/4” woofer installation)
• 5-3/4” Hole Saw (6-1/2” woofer installation)
WARNING:Window mechanisms and electrical wires and other expensive car
parts have a nasty habit of hiding where you least expect. CHECK BEFORE
YOU DRILL!
Step 5: Run the speaker wire to the speakers. Make sure to keep wires away
from sharp metal or other edges. When passing through metal, use a
protective grommet.
Step 6: Using the plastic grille ring as a template, mark the mounting holes with
a pen.
Step 7: Pre-drill mounting holes using a 1/8” drill bit.
WARNING:Window mechanisms and electrical wires and other expensive car
parts have a nasty habit of hiding where you least expect. CHECK BEFORE
YOU DRILL!
3