Cygnett i-x6 Portable Speaker User Manual


 
Features 4
Rear Panel Features (continued)
8. Volume Control: The volume control allows you to set the output
level of your i-X5 (Note: this function is independent of the iPod
volume level).
9. Vent Port: This port aids in reproduction of very low frequencies
by discharging frequencies below 55Hz.
10. 6.5mm Jack Output: Use the 5 metre speaker cable included to
connect the left and right speakers through the 6.5mm jacks on
the back of each speaker.
11. Power Switch: This switch turns the device on and off, The 'ON'
position is marked with a white dot.
12. Power Receptacle: Accepts a detachable 3-circuit line cord in
order to power the device.
13. Voltage-Select Switch: Provides 2 selections, 115VAC and
230VAC, and should be set to match the “house supply”
(receptacle) voltage of the country or location in which the
speaker is used. The 115V setting is correct for the USA, while
the 230V setting is correct for most of the UK, Europe and
Australia. This setting must be correct or damage to the speaker
will occur.