Filter
Top Products
Operation Guide DQ-980
2
GENERAL GUIDE
11
11
1 SNOOZE/LIGHT button
• Press this button to illuminate the display for about five seconds.
• Pressing this button while the alarm is sounding stops the alarm.
2 32 3
2 32 3
2 3
+
/
–
buttons
• Use these buttons to change the setting that is flashing on the display.
44
44
4 Alarm Mode selector
SNZ: Snooze alarm on
ON: Alarm on
OFF: Alarm off
55
55
5 DEMO button
• Press this button to sound the alarm.
66
66
6 SET button
• Use this button when setting the current time.
77
77
7 RESET button
• Press this button to reset the clock after replacing its battery.
USING THE CLOCK
1. Press the SET button (6) to cycle through the setting screens as shown below.
12-hour/24-hour Setting Screen Time Setting Screen
Month and Day Setting ScreenYear Setting ScreenNormal Timekeeping Screen
2. While the screen you want is displayed, use the + and – buttons (2 3) to change the flashing digits.
• Holding down + or – changes the flashing digits at high speed.
• You can set the year in the range of 2000 to 2069. The day of the week is set automatically in accordance
with the date setting.
• Pressing + or – while the Time Setting Screen is on the display causes the seconds count to be reset to 00.
• Each press of + or – while the 12-hour/24-hour Setting Screen is on the display toggles between 12-hour and
24-hour timekeeping.
(+) Increase
(–) Decrease
3. After making the settings you want, use the SET button (6) to display the Normal Timekeeping Screen.
• The clock automatically returns to the Normal Timekeeping Screen if you leave a setting screen on the display
for about five minutes without performing any operation.
USING THE ALARM
The alarm sounds when the alarm time you set is reached. You can also use the Alarm Mode selector (4) to
select the snooze alarm feature.
Setting the Alarm Time
Use the + and – buttons (2 3) to set the alarm time.
Pressing the + and – buttons (2 3) causes the alarm time to appear in place of the date on the display.
(+) Increase
(–) Decrease
• Holding down + or – changes the digits at high speed.
Turning the Alarm On and Off
Use the Alarm Mode selector (4) to turn the alarm on and off, and to select the snooze feature.
• The alarm time appears in place of the date on the display whenever the Alarm Mode selector (4) is set to ON
or SNZ.
• The volume of the alarm sound cycles through five levels as it sounds.
Stopping the Alarm
• When the alarm is sounding, press the SNOOZE/LIGHT button (1) to stop it. When the snooze feature is turned
on, the alarm will sound again in about five minutes.
• To turn off the snooze feature, slide the Alarm Mode selector (4) to OFF.
Demo Alarm
Press the DEMO button (5) to sound the alarm.
THERMOMETER FUNCTIONS
• Display Range: –19.9°C (Under: LL) to 49.9°C (Over: HH)
• Guaranteed Range: 0°C to 40°C
HYGROMETER FUNCTIONS
• Display Range: 20% (Under: LL) to 90% (Over: HH)
• Sensor Precision: ±10% when temperature is 5°C to 40°C.
Alarm Mode selector
SNZ ( )
ON ( )
OFF
Description
The alarm sounds at the preset time for one minute, and up to seven more times every
five minutes thereafter. Even if you stop the alarm by pressing the SNOOZE/LIGHT button
(1), the alarm sounds again about five minutes later.
• The indicator
flashes on the display to indicate that the snooze feature is
activated.
The alarm sounds at the preset time for one minute.
The alarm does not sound.