Filter
Top Products
Page 18
through the other source.You can still listen to the CCRadio
plus
while using the LINE OUT jack.
TIMER ACTIVATION SWITCH
The black jack labeled with this symbol is for use with a recorder that
has a timer activated switch.You would use this switch if you wanted to
do a timed recording. It is used in conjunction with the LINE OUT jack.
See your recorder for specific instructions.
SETTING THE TIMER
Please read this entire page carefully before you start. You will need
to go through the 3 steps listed below without stopping. If you stop
for more than 15 seconds, you will need to press and hold the
Timer Button until you hear a single beep.Then start at step one
again.
Before you begin, program the stations that you will want to record into
memory. Refer to page 13 for instructions on programming memory pre-
sets. The timer has an ON TIME and an OFF TIME. You must set both
in order for the timer to work correctly.
STEP 1:TO SET THE ON TIME
1) Press and hold the Timer/Set Button until you hear a double beep
and the word
ON
, the hour digit and
TIMER
flash on the display.
2) Use the Tuning Up/Down Buttons to set the hour, verifying that the
time is set correctly for AM or PM as shown on the display.
3) Press the Timer/Set Button again so the minutes and the word
ON
and
TIMER
flash on the display.
4) Use the Tuning Up/Down Buttons to set the minutes.
STEP 2:TO SET THE OFF TIME
1) Press the Timer/Set Button again until the word
OFF
, the hour digit
and
TIMER
flash on the display.
2) Use the Tuning Up/Down Buttons to set the hour. Again, verify that
the time is set correctly for AM or PM.
3) Press the Timer/Set Button again so the word
OFF
and
TIMER
and
the minutes, flash on the display.
4) Use the Tuning Up/Down Buttons to set the minutes.
STEP 3:TO SET THE FREQUENCY
1) Press the Timer/Set Button again to select your desired frequency.
The word
TIMER
and the memory preset will flash on the display.
Using the Band Button, select the appropriate band (AM, FM, TV or
WX). Press the memory button 1-5 that corresponds with your
desired station.
2)
You must Press the Timer/Set Button again to complete the setup.