Bosch Appliances PB10 Portable Radio User Manual


 
10
3. Press the button again to turn BOSCH SOUND back on.
TO ADJUST VOLUME
1. Turn right (clockwise) VOLUME+ knob on the front panel
1/8th of a turn once to increase the sound level by 1 degree,
and
“VOL X” appears on the LCD display.
2.
Turn right (clockwise)
VOLUME+ knob and hold it, the
volume keeps increasing upward until you select it, and then
release the knob.
“VOL XX” goes up rapidly on the LCD
display.
3. Turn left (counterclockwise)
VOLUME– knob on the front
panel 1/8th of a turn once to decrease the sound level by 1
degree, and
“VOL X” appears on the LCD display.
4. Turn left (counterclockwise)
VOLUME– knob and hold it,
the volume keeps decreasing downward until you select it, and
then release the knob.
“VOL XX” goes down rapidly on the
LCD display.
Releasing and Inserting
Battery Pack
To release or insert the battery pack from radio unit, open
the charger door by unlocking the latch. Before inserting
battery pack, remove protective cap from battery pack. To
insert battery, align battery and slide battery pack into tool
until it locks into position. Do not force.
Charging Battery Pack
CHARGER OPERATION:
Insert battery and close door.
Charge only Bosch batteries BAT025-
BAT045. Other batteries may burst
causing injury and damage. Read additional safety
information on underside of radio.
Open charger door by releasing latch. Plug the unit’s power
cord into your standard power outlet. Before inserting battery
pack, remove protective cap, then insert battery pack into
charger.
1.
The LCD will display the battery “ICON” and “CHARGING”
on the front of the unit. This indicates he battery pack is
charging.
2. When “CHARGING” disappears, charging is complete
3. If when you begin the charging process of the battery
pack, the “THERMOMETER ICON” is displayed on the LCD,
this indicates the battery pack is too hot or too cold.
The battery pack will begin to charge once it reaches the
proper temperature. The thermometer will disappear when it
begins to charge.
4.The purpose of the charging icon on the LCD is to indicate
that the battery pack is fast-charging.
The charging icons
will disappear in less time if the battery pack was not
completely discharged.
5. When the battery pack is fully charged, the battery pack
can be inserted into a tool, or used to power the radio
instead of the power cord.
To prevent fire or injury when batteries
are not in tool or charger, always place
protective cap onto end of battery pack.
DOOR
RELEASE
LATCH
BATTERY
PACK
PROTECTIVE
CAP
WARNIN
G
!
WARNIN
G
!