Filter
Top Products
Page 11
724-746-5500 | blackbox.com
Chapter 4: Configuration and Setup
Step 3. Insert the loop created in Step 2 through the rear small hole at the top of the
divider (Figure 4-4). Then, place the plug end of the wire through the loop (Figure
4-5). Make sure that the loop is on the side of the divider (not on top of it—see
Figure 4-6). This will ensure that the divider will slide back into the cart. Then, tighten
the loop down to the divider, tightening the knot.
Figure 4-5. Insert the plug end of the wire through the loop.
Keep the loop here
Power brick end
Figure 4-6. Make sure the loop is on the side of the divider, not on top of it.
Step 4. Run the wire along the top of the divider and repeat the process of creating
a loop in the power cord. Place this loop through the small hole at the front of the
divider (Figure 4-7). Now place the plug end of the wire through the loop (Figure
4-8). Pull the end of the cable, tightening the loop (Figure 4-9).
Figure 4-7. Create a loop from the power cable and feed it through the hole at the
top front of the divider.
NBC20S