Filter
Top Products
behringer.com
14 XENYX X1622USB/X1832USB/X2222USB/X2442USB User Manual
MAIN SOLO
The MAIN SOLO LED lights up as soon as a channel or aux send solo switch
is pressed. The MODE switch must be set to “Solo”.
PFL (LEVEL SET)
The PFL (LEVEL SET) LED indicates that the peak meter is set to PFL mode.
PHONES jackFig. 2.17:
PHONES jack
You can connect headphones to this ¼" stereo jack (X2442USB: 2 phones jacks).
The signal routed to the PHONES connection is the same as that routed to the
control room output.
Subgroups and main mix fader2.3.12
You use the high-precision quality faders to control the output level of the
subgroups and the main mix.
LEFT/RIGHT switch
The switches located above the subgroup faders assign the subgroup signal
either to the left or right side of the main bus. Similarly, it can be routed to
both sides or none at all. In the latter case, the submix is present only at the
corresponding subgroup outputs.
Subgroup and main mix faderFig. 2.18:
Graphic 9-Band Equalizer 3.
(X1832USB only)
The graphic stereo equalizer of the X1832USBFig. 3.1:
The graphic stereo equalizer allows you to tailor the sound to the room acoustics.
EQUALIZER
Use this switch to activate the graphic equalizer.
MAIN MIX/MONITOR
This toggles the graphic equalizer between the main mix and the monitor
mix. With the switch up (not depressed), the equalizer is active in stereo on
the main mix, and inactive on the monitor mix.
When the switch is depressed the equalizer is active in mono on the monitor mix,
and inactive on the main mix.
FBQ FEEDBACK DETECTION
The switch turns on the FBQ Feedback Detection System. It uses the LEDs in the
frequency band faders to indicate the critical frequencies. On a per-need basis,
lower the frequency range in question somewhat in order to avoid feedback.
The graphic stereo equalizer has to be turned on in order to use this function.
Logically, at least one (ideally several) microphone channels have to be ◊
open for feedback to occur at all!
Feedback is particularly common when stage monitors (“wedges”) are concerned,
because monitors project sound in the direction of microphones.
Therefore, you can also use the FBQ Feedback Detection for monitors by
placing the equalizer in the monitor bus (see MAIN MIX/MONITOR).
Digital Eects Processor4.
24-BIT MULTI-EFFECTS PROCESSOR
Here you can nd a list of all presets stored in the multi-eects processor.
This built-in eects module produces high-grade standard eects such as reverb,
chorus, anger, delay and various combination eects. Use the Aux Send FX on
the channels and the Aux Send FX master control to determine the input signal
of the eects processor.
X2442USB
X1832USB