Filter
Top Products
59
OPERATION
INITIAL SETUP
This unit defaults to cable TV mode. When the unit is first powered on, it will detect the
cable system and auto-program the TV tuner to the available stations. Please wait while
the unit auto-programs before attempting to operate the unit. During this time the unit
will not respond to any commands. The unit will respond normally once the cable mode
and channel search mode is concluded.
CHANNEL TUNING SETUP
If you are Cable TV subscriber, in addition to normal broadcast reception of VHF and
UHF channels, your new TV is capable of receiving many unscrambled Cable channels
without the use of a converter box. When set to broadcast (AIR) TV, it receives CH2-
CH69. When set to one of the CATV modes (STD, HRC, or IRC) it receives CH1-CH125.
NOTE: Most cable companies broadcast in STD Mode
After a power interruption, the unit will go into a cable mode search (HRC, IRC, STD)
and channel search mode automatically. During this time the unit will not respond to
any commands. The unit will respond normally once the cable mode and channel
search mode is concluded.
POSITIONING THE SCREEN
Press the screen lock button and pivot the screen forward until a comfortable viewing
angle is reached. The screen may also be rotated from side to side. Do not force the
screen beyond its rotational limit. The VE720E/VE920E is now ready for use.
Pressing the ON/OFF button on the unit or the remote will turn the system on or off.
Remember to turn the unit off and pivot the screen to the closed position when not in
use to prevent damage to the screen.
SETTING THE TIME
NOTE: All settings (except setting the presets) are performed with the VE720E/VE920E
turned OFF.
1) Press the SET button and the minutes will flash.
2) Use the CH up/down button to set the minutes.
3) Press the SEEK button to toggle between the hour and minutes.
4) Use the CH up/down button to set the hour. (Check AM/PM indicator)
5) Press the ON/OFF button to return to the time display.