Filter
Top Products
Drill holes 4mm in diameter.
PROCEDURE FOR HORIZONTAL INSTALLATION
1
2
3
Bracket (R)
Attach bracket (L) and bracket (R) to each side of the unit,
using the hexagonal bolts with washer base (M5 x 8).
Determine the mounting location, and drill four mounting
holes.
Secure the unit in place, using four self-tapping screws
(M5 x 12).
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
3
INSTALLATION
Self-tapping screw (M5 x 12)
Never mount the unit near the fuel tank.
The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side),
must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration
compensation will not be effective and vibration may cause the disc to skip.
CAUTION
After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used to keep dust, which could
cause a malfunction, out of the unit.
position "H"
position "V"
position "45°"
Bracket (L)
Bracket (R)
Bracket (L)
Hexagonal bolt
with washer base (M5 x 8)
Anti-vibration
springsposition
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.
HORIZONTAL INSTALLATION
Set the 4 anti-vibration springs to
position "H".
VERTICAL INSTALLAITON
Set the 4 anti-vibration springs to
position "V".
45° ANGLE INSTALLATION
Set the 4 anti-vibration springs to
position "45°".