Filter
Top Products
20
O. Setup
1. General Setup Page
1)With no disc inside the player, press ‘SETUP’ to display the Main screen
of the Setup Menu on the screen and “General Setup Page” appears. At
the same time, “
” is highlighted. Press ‘SETUP’ again to exit the
Setup Menu.
2)Press the ENTER button, “TV Display” is highlighted.
3) Press the
or
buttons to select the other menus in general setup
page.
4) Press
to enter the sub menu.
5) Press the
or
button to select the desired option in the sub
menu and press the ENTER to confirm your selection.
6) Repeat steps 3-5 for other menus.
Note: Press
to return the previous menu.
a) TV Display
* Normal/PS: When the player outputs signal to a normal TV, a nor-
mal picture is shown on the full screen.
* Normal/LB: When the player outputs signal to a normal TV, a nor-
mal picture is shown on the screen with a black strip at both the top
and bottom of the screen.
* Wide: When the player outputs signal to a wide screen TV, a
wide picture is shown on the full screen.
b).Angle Mark
* On: The screen will show the angle mark icon. (*If an angle option is
available).
* Off: The screen will not display the Angle Mark
NOTE: Not all discs contain above features. The above features are
disc dependent.
c) Screen Saver
*On: Enables screen saver
*NOTE: The DVD player will enter the Screen Saver mode after ap-
proximately three minutes if the same image remains on the screen.
*Off: Disables screen saver (off)