Filter
Top Products
After selection of the mounting location, mark the hole to
be cut out. A template is provided in the speaker box.
Locate and level the template, then mark with pencil on
the wall surface. If you are unsure whether there are
obstructions behind the wall surface where the speakers
are to be mounted cut a small hole in the center of your
marked mounting location. Holding you drywall saw at a
45 degree angle (see Fig. 2) cut a square hole that you
can use to find any obstructions, should they exist.
The 45 degree wedge shape of the removed surfacing
material will make replacement, if necessary, a much
easier task and yield a better finish when patching the
work.
Once it has been determined that there are no obstruc-
tions cut the hole to mount the speaker using the drywall
saw at a 90 degree angle to the wall surface. Cover the
raw edges of the wallboard with masking tape
(see Fig. 3). This will prevent the back pressure of the
speaker from blowing loose gypsum dust out and on to
the painted wall surface after installation. Do not allow
the tape to extend more than 1/4” beyond the edge of
the hole into the room. The frame of the AS6s will cover
and hide the tape.
Next you will want to run your speaker wire to your
speaker locations. A UL rated CL3 speaker wire is
recommended when running wire inside your walls.
In many areas it may be required by code. When
running your speaker wire you should avoid having the
speaker wire run parallel to the 110V power lines to
avoid picking up hum and interference from the power
service. If the speaker wire needs to cross a 110V power
line at a right angle this is acceptable and should not
create a problem.
If you are uncomfortable with running the speaker wire
yourself in existing construction, it is recommended that
you retain a qualified custom home installation specialist
or electrician.
Installing the Speakers
Installation Tip! To further enhance the performance of
your AS6s speakers, the wall stud cavity where you plan
to place your speakers can be stuffed with a generous
quantity of fiberglass insulation. If uninsulated, stuff the
area above and under the speaker opening with 6” thick
insulation to a depth of approximately 2 feet beginning 1
foot above of and 1 foot below the speaker opening. If
the insulation is foil or paper backed, face the backing
away from the AS6s speaker. The addition of this
insulation will help to prevent the unwanted transfer of
sound into the otherwise large and resonant cavity of the
uninsulated wall.
ROOM
ROOM
Masking T.ape
Figure 3
Figure 2
It is now time to connect the speaker wire to the AS6s.
Your speaker wire is usually coded to identify each
conductor as either positive or negative. This can be by
color coding, or one conductor may have a printed
marking or at least a rib along one edge that you will not
find on the other. Identify which type of polarity coding
that your wire is using. You must carefully observe that
the positive terminal of the speaker output on your
amplifier is connected to the positive terminal of the
AS6s speaker. Likewise, the negative terminal of the
amplifier’s speaker output should be connected to the
negative terminal of the AS6s speaker.
Next make sure that the doglegs are positioned inside
the frame of the speaker.
With the grill removed, place the speaker in the wall
opening. Make sure that the speaker wire is not hanging
against the speaker where it can vibrate and rattle as the
speaker reproduces your music.
Next, one at a time, turn
each of the six screws that
operate the doglegs
counter clockwise a few
turns until you feel the
dogleg is loose from its
resting position. Now turn
the screw clockwise until
you feel the dogleg contact
the wall surface.
(+) Amp
(-) Amp
Correct
Incorrect
1
2
34
5
6
2
AS6s
6.5” Two Way In-Wall
100W / 8 ohm
AS6s
6.5” Two Way In-Wall
100W / 8 ohm