Filter
Top Products
PXI 8P
©American Audio® - www.AmericanAudio.us - PXI 8P™ - Instruction Manual Page 7
P
XI 8P™ Rear Panel Controls and Features
Rear Panel:
9. XLR PARALLEL OUTPUT JACK – This jack is used to send the incoming line level signal from
either of the Line Level Inputs Jacks to another PXI 8P™ or other line level input jack such as
a mixer or power amp.
10. BALANCED XLR LINE INPUT – This connection is designed to accept a balanced line input
signal from a mixer or other line level device with a balanced output jack. Use a balanced cable
when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be sure to
connect only line level input devices such as mixers and tape machines to this jack.
11. MIC XLR INPUT JACK - This jack is used for Microphone and line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such
as Rhythm Machines or Samplers should also be connected to the LINE inputs.
12. MICROPHONE 1/LINE LEVEL INPUT LEVEL – This knob is used to regulate the output signal
of the microphone or CD player/tape deck that is connected to the Mic and Line Level jacks (10
& 11).
13. POWER LED - This L.E.D. will be lit when you switch on the power.
14. CLIP L.E.D. - When your Mic 1 or Line Level Speaker Levels are distorted or too loud this
L.E.D. will light letting you know to adjust your volume level to a lower setting.
15. VOLTAGE SELECTOR SWITCH - Because power supplies vary from location to location a
voltage selector switch has been incorporated in the unit's design. This switch can select a
voltage input of 115v or 230v to accommodate the two major power source. Always be sure
to disconnect the power plug before changing the voltage.
10
15
14
13
12
11
9
16
18
17