©American Audio® - www.AmericanAudio.us - Flex 100MP3 Instruction Manual Page 20
BASIC OPERATIONS (CONT.)
3) Press the to set the ending point for your SEAMLESS
LOOP (Figure 20). TheandLEDs will
immediately begin to flash rapidly, indicating the SEAMLESS LOOP mode
has been activated.
- During a seamless loop, the and
will turn on in theindicating a
loop is active.
- To exit a SEAMLESS LOOP, press the
Theand LEDs will
remain on, but will stop flashing. Music playback will resume normal
play. The and LEDs will remain
on to remind you that a loop is stored in memory.
- The function allows you to return to your
stored loop at any time. TheandLEDs
will indicate a loop is stored in memory, and may be played at any time.
To replay the loop, press the The
and LEDs will again begin to flash indicating SEAMLESS
LOOP mode has been activated and your stored loop will immediately begin
to play.
11. EDITING A LOOP:
Please note: Only the ending point of the loop may be edited. You may make your loop shorter or longer. Before
you can edit your seamless loop you obviously must first create a seamless loop to edit. If you haven’t created
a SEAMLESS LOOP, follow the instructions in step 10 to create a loop. If a SEAMLESS LOOP has already been
created, press the to activate your SEAMLESS LOOP (Figure 22) if it is not already
activated. To edit your seamless loop’s ending point:
1) Press theto return to normal play from the loops cue point. (Figure 21). This will
disengage the SEAMLESS LOOP mode and allow you to edit the loops ending point.
2) Press theagain when you reach your new ending point (Figure 21).
- FOR A SHORTER LOOP: Press theat sooner point in the track (Figure 21).
- FOR LONGER LOOP: Press theat later point in the track (Figure 21).