Filter
Top Products
8
4.2 LTO MS1 SPEAKER MODELLER
- THE FRONT PANEL
1. Gain Control
This control adjusts the input gain by a range of -20 dB to +20dB.
2. Clip LED
This LED lights up when the input signal is too strong. It warns that the output signal may cause distortion.
Please attenuate the level of the input signal.
3. Presets Selector
Via this knob, you can select the right effect you wish to perform. There are total 16 options for you, JAZZ
CLUB+SUB, WIRTUAL SUB, STAGE MONTOR, JAZZ CLUB, CONCERT HALL+SUB, DISCO, VOCAL,
ROCK & ROLL, FLAT, DRUM KICK, ANTIRUMBLE, COBCERT, CONCERT HALL, ARENA+SUB, LOUDNESS,
ROCK & ROLL+SUB, ACOUSTIC and JAZZ CLUB+SUB.
MS1
LTO
R
VIRTUAL SUB
STAGE MONITOR
JAZZ CLUB
CONCERT HALL+SUB
DISCO
VOCAL
ROCK & ROLL
JAZZ CLUB+SUB
DRUM KICK
ARENA+SUB
LOUDNESS
ROCK & ROLL+SUB
ACOUSTIC
ANTIRUMBLE
CONCERT HALL
CLIP
MIN MAX
POWER
SPEAKER MODELLER
0dB
GAIN
FLAT
(1) (2) (3) (4)
4. Power LED
This LED lights up when the unit is powered on.
-THE REAR PANEL
5. AC Inlet
This jack is used to connect the AC power supply with the supplied 15V AC adapter.
6. Output Connector
This is a balanced 1/4" TRS jack, which is used to connect devices such as the effects returns on a mixing
power amplifier inputsconsole or .
7 Input Connector.
This is a balanced 1/4" TRS jack, which connects to sources such as the effect sends of mixing console.
(5) (6) (7)
15VAC~
POWER
LEFT
LEFT(MONO)
RIGHT RIGHT
TIP/PIN2
RING/PIN3
SLEEVE/PIN1
INPUT
OUTPUT
TIP/PIN2
RING/PIN3
SLEEVE/PIN1