Tesco.com CR112DABV Manual

Open as PDF

next previous

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with a slightly damp cloth.

Do not block any ventilation openings.

Install in accordance with the manufacturer’s

instructions.

Do not install or operate near any heat sources

such as radiators, stoves, or other apparatus that

produce heat.

Unplug this apparatus during lightning storms or

when unused for long periods of time.

Refer all servicing to qualied service personnel.

Servicing is required when the apparatus has

been damaged in any way, such as the power-

supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus,

the apparatus has been exposed to rain or

moisture, does not operate normally, or has been

dropped.

Warning: To reduce the risk of re or electrical

shock, do not expose this product to rain or

moisture. The product must not be exposed to

dripping and splashing and no object lled with

liquids such as a vase of owers should be placed

on the product.

No naked ame sources such as candles should

be placed on the product.

Caution: Changes or modications not expressly

approved by the manufacturer could void the

user’s authority to operate this device.

Caution: Usage of controls or adjustments or

performance of procedures other than those

specied herein may result in hazardous

exposure.

IMPORTANT

This equipment generates, uses and can radiate

radio frequency energy and, if not installed

and used in accordance with the instructions,

may cause harmful interference to radio

communication. However, this is no guarantee

that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which

can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment

and receiver.

- Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

ELECTRICAL INFORMATION

Mains Supply: The mains operating voltage of

this unit is marked on a rating plate on the rear

of the unit.

The means of disconnecting this appliance from

the mains supply is the mains plug. This should be

unobstructed and readily operable at all times.

Tesco Stores Ltd, Delamare Road, Cheshunt,

Herts, EN8 9SL

CAUTION!

RISK OF ELECTRIC SHOCK

DO NOT OPEN

TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER (OR BACK)

This symbol indicates that there are impor-

tant operating and maintenance instructions

in the literature accompanying this unit.

This symbol indicates that dangerous

voltage constituting a risk of electric shock

is present within this unit.

IMPORTANT SAFETY INFORMATION PRELIMINARIES

FITTING BATTERIESREAR / UNDERSIDE VIEW

TOP VIEW

UNPACKING

Carefully unpack the unit. If it is damaged,

please return it to your nearest Tesco store for

replacement. Remember to take your purchase

receipt with you.

Retain the User Handbook. If you pass the unit

on to a third party make sure you pass on the

handbook.

We suggest you retain the packaging. If you

dispose of it, do so having regard to any recycling

regulations in your area.

CONTENTS

The carton should contain:

• The CR112DABV digital radio

• Operating Manual

If any items are missing or damaged, contact your

nearest TESCO store for a replacement. Have

your receipt ready when you call.

Retain the packaging.

If you dispose of it, do so having regard to any

recycling regulations in your area.

LOCATION

Place the unit on dry stable surface away from

heat and damp and where it is unlikely to fall or

be knocked over.

1. Speaker

2. PRESET button

button

5. BACK/SCAN button

Un clip the battery cover in the direction indicated.

Lay the ribbon over the battery compartment.

Batteries are to be placed on top of the ribbon.

Fit 6 x AA batteries in the sequence shown,

observing polarity.

Ret the battery cover.

Switching on your radio for the rst time

1 Mains Adaptor (supplied with the package)

Connect the mains adaptor to the DC power

socket on the rear of the radio ( if not using

batteries ).

2 Extend the pig tail aerial as far as it can go.

3 Slide the Power ON/OFF switch to ON to turn

on the radio.

The radio will automatically tune and operate the

quick scan.

During scan mode, the LCD will display a slide

bar that indicates the progress of the scan, and

the amount of radio stations that have been

found so far.

Once the scan has nished, the radio will select

the rst alphanumeric station.

NOTE: The station name will be shown on the

top of the display. Information about the DAB

radio station will be displayed on the bottom of

the display

Preset Memory

When you power up the radio again, the radio

plays in the same mode (DAB or FM) as last

chosen.

If you hear no sound, then press the “VOL +”

control until you reach a desired level.

If the volume is too high, then press the “VOL -”

control to decrease the volume level.

To listen to your desired stations press either

the

/ buttons to cycle through the stored

stations. When you reach your desired station

stop pressing the

/ buttons and the radio will

automatically tune to that station. The display will

now change to show the station name on the top

of the screen and information about the station on

the bottom of the screen.

Press the (standby) button to turn off the radio.

To turn the radio on press the

(standby) button.

1. To set manually, press and hold the

INFO/MENU button for 3 seconds.

2. When the <Scan Setting> option appears press

either

or and nd <System>.

3. Press the ENTER button, use the / buttons

to nd <Time> and press ENTER.

Inside the <Time> menu there are several

options. <Set 12/24 Hour>, <Set Time/Date>,

<Auto Update> & <Set Date Format>.

<Set 12/24 Hour> Use the / buttons to select

12 or 24 hour and then press the ENTER button

to activate.

<Set Time/Date> When activated the hour digit

ashes, use the / buttons to set the digit to

the correct hour then press ENTER, repeat for the

minutes again pressing ENTER when set.

The process for setting the date is exactly the

same as the above. Press ENTER to nalise the

setting once complete.

<Auto Update> Use the / buttons to cycle

through the various options for auto setting the

time & date. These range from. <Update from

any>, < Update from DAB>, < Update from FM>

and <No Update>.

NOTE: When the power is switched OFF ( not

standby ) the settings will be lost.

<Set Date Format> Use the / buttons to

set DD-MM-YYYY or MM-DD-YYYY. Press the

ENTER button to store.

To nalise selections do not touch any buttons

for ten seconds. The unit will exit to the station

selection screen.

Alarm Setting

1. Press and hold the INFO/MENU button for 3

seconds.

2. When the <Scan Setting> option appears press

either or and nd <System>.

3. Press the ENTER button, use the / buttons

to nd <Alarm> and press ENTER.

Alarm Setup

Press ENTER to initiate the setup process.

1. Use the / buttons to select Alarm 1 or

Alarm 2 then press ENTER to activate.

2. Use the / buttons to select Alarm ON or

OFF then press ENTER to set.

3. Use the / buttons to set the Alarm ON hour

digits. Press ENTER to set.

4. Set the Minute digits the same way and press

ENTER once set.

5. Choose the source of the alarm between

BUZZER, DAB & FM using the /

buttons.

If you choose DAB or FM the next step is to

choose the station you want to play.

Welcome to

Digital Radio

Scanning...

6. ENTER button

7. Display

8. SNOOZE/SLEEP button

(standby) button

10. INFO/MENU button

11. DAB/FM button

12. VOLUME -

13. VOLUME +

14. 1-10 Preset buttons

6. There is the option to only have the alarm

activate on WEEKDAYS, DAILY and

WEEKENDS. Choose which you require using

the / buttons.

The ENTER button stores the setting.

7. The next step is to set the volume level you

require. use the / buttons to set

and press ENTER to activate the alarm.

8. To disable the alarm return to the <Alarm>

screen and use the / buttons to

choose OFF and press ENTER to save.

9. To silence the alarm when sounding press the

ENTER button.

10. Repeat the procedure 1-9 to set Alarm 2.

NOTE: In standby the alarm icon

will display

when activated.

Snooze Mode

When the alarm sounds you can press the

SNOOZE/SLEEP / button to activate the

SNOOZE mode and delay the alarm for 5

minutes.

SNOOZE/SLEEP

1-6 2-7 3-8 4-9 5-10

PRESET

VOL

BACK/

SCAN

INFO/

ENTER

DAB/FM

OPEN

RIBBON

1615 17 18

6 87 9 121110 13 14

SNOOZE/SLEEP

1-6 2-7 3-8 4-9 5-10

PRESET

VOL

BACK/

SCAN

INFO/

ENTER

DAB/FM

OPEN

RIBBON

1615 17 18

6 87 9 121110 13 14

SNOOZE/SLEEP

1-6 2-7 3-8 4-9 5-10

PRESET

VOL

BACK/

SCAN

INFO/

ENTER

DAB/FM

OPEN

RIBBON

1615 17 18

6 87 9 121110 13 14

SNOOZE/SLEEP

1-6 2-7 3-8 4-9 5-10

PRESET

VOL

BACK/

SCAN

INFO/

ENTER

DAB/FM

OPEN

RIBBON

1615 1718

6 87 9 121110 13 14

GETTING STARTED GENERAL OPERATION GENERAL OPERATION

DAB/FM clock radio

CR112DABV

Owners Handbook

SNOOZE/SLEEP

1-6 2-7 3-8 4-9 5-10

PRESET

VOL

BACK/

SCAN

INFO/

ENTER

DAB/FM

15. Antenna

16. POWER switch

17. DC power input

18. EARPHONE output

19. Battery compartment

2 3 4