Sony WM-FX290 MP3 Player User Manual


 
3-261-583-71 (1)
Radio
Cassette Player
©2004 Sony Corporation
WM-FX290
Operating Instructions
English
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Listening to the Radio
1 If the HOLD function is turned on, set the
HOLD switch in the opposite direction of the
G mark to unlock the controls. Make sure
that the tape has stopped completely.
2 Press FM or AM to select the desired band
and to turn on the radio.
3 For manual tuning:
1 Press MENU repeatedly to set “_” (the
cursor) in the display to TUNE MODE
and press SET to choose “MANUAL”.
2 Press PRESET/TUNING + or – repeatedly
to tune in to the desired station.
Hold down PRESET/TUNING + or – for a
few seconds to scan for stations.
For preset tuning:
1 Press MENU repeatedly to set the cursor
in the display to TUNE MODE and press
SET to choose “PRESET”.
2 Press PRESET/TUNING + or – repeatedly
to recall the desired preset station.
To use preset tuning, preset the station
first (see “Presetting Radio Stations”).
To turn off the radio
Press RADIO OFF.
To improve broadcast reception C
For FM: Extend the headphones/earphones cord
(antenna). If the reception is still not good, press
MENU repeatedly to set the cursor in the display to
FM MODE. Then press SET to switch between
“LOCAL” and none (DX), or “MONO” and none
(stereo) for best reception.
For AM: Reorient the unit itself.
Presetting Radio Stations
You can preset up to 40 stations.
For Canada and Central/South America: 30 for FM
and 10 for AM.
For other countries: 35 for FM and 5 for AM.
Presetting Automatically Scanned
Stations
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press and hold ENTER for more than 3
seconds.
Preset number 1 will flash in the display and
the Walkman starts scanning the stations
from the lower frequencies and stops for
about 5 seconds when a station is received.
3 If you wish to preset the currently received
station, press ENTER while the preset
number is flashing.
The received station is preset on preset
number 1 and the unit starts scanning for the
next receivable station.
4 Repeat step 3 until all receivable stations are
preset.
To stop scanning
Press RADIO OFF. The radio is turned off at the same
time.
Notes
If stations are already stored, the newly preset stations
replace the old ones when the above procedure is
completed.
If stations cannot be preset automatically, preset them
manually.
Presetting Stations Manually
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press ENTER.
The frequency digits will flash in the display.
3 While the frequency digits are flashing, tune
in to a station you wish to store using
PRESET/TUNING + or – and press ENTER.
The preset number will flash in the display.
4 While the preset number is flashing, select
the preset number you want using PRESET/
TUNING + or – and press ENTER.
Notes
If you cannot complete step 3 or 4 while the indicators
are flashing, repeat from step 2.
If a station is already stored, the new station replaces
the old one.
Playing the Preset Radio Stations
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press MENU repeatedly to set the cursor in
the display to TUNE MODE. Then press SET
to display “PRESET”.
3 Press PRESET/TUNING + or –.
To cancel a stored station
1Follow the procedure above and in step 3, select the
preset number you want to cancel and then press
ENTER. The frequency digits will flash in the
display.
2Press and hold PRESET/TUNING + or –. The
frequency digit starts running up or down. Keep
holding down the button until “- - - -” is displayed.
3Press ENTER while “- - - -” is flashing. A preset
number will flash in the display.
4Press ENTER to cancel the stored station.
Scanning the Preset Radio Stations
— DAPS
(Digital Auto Preset Scanning)
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press and hold FM or AM pressed in step 1
for 2 seconds or more.
The preset stations of the selected band will
be played for about 5 seconds each. (During
DAPS the indicators in the display flash.)
3 Press FM or AM again to select the station
while the desired preset station is being
played.
Notes
If there are no stations stored, the DAPS function does
not work.
Until a station is selected in step 3, the DAPS function
turned on in step 2 will continue.
In step 2 or 3, if you select a band which you did not
select in step 1 by pressing FM or AM, the newly
selected band will be played normally.
Using Other Functions
Locking the Controls
Set the HOLD switch in the direction of the G mark to
lock the controls.
The HOLD function only locks the radio operation
buttons, MENU, SET, PRESET/TUNING + or – and
ENTER.
Emphasizing Bass Sound
Press MENU repeatedly to set the cursor to MB (mega
bass) in the display. Then, press SET to turn MB on.
With each press, the indications change as follows.
MB (mega bass) : emphasizes bass sound
No message: off (normal)
Notes
If the sound is distorted with the mode “MB”, turn
down the volume or select normal mode.
Bass emphasis may not show great effect if the volume
is turned up too high.
Protecting Your Hearing—AVLS
(Automatic Volume Limiter System)
Press MENU repeatedly to set the cursor to AVLS in
the display. Then press SET to show “ ”.
The maximum volume is kept down to protect your
ears.
Precautions
On batteries
Do not carry dry batteries with coins or other metallic objects. It
can generate heat if the positive and negative terminals of the
batteries are accidentally contacted by a metallic object.
When you are not going to use your Walkman for a long time,
remove the battery to prevent damage from battery leakage and
corrosion.
On handling
Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or sand, moisture,
rain, mechanical shock, or in a car with its windows closed.
•We do not recommend the use of tape longer than 90 minutes.
They are very thin and tend to be stretched easily. This may
cause malfunction of the unit or sound deterioration.
The LCD display may become hard to see or slow down when
using the unit at high temperatures (above 40°C/104°F) or at
low temperatures (below 0°C/32°F). At room temperature, the
display will return to its normal operating condition.
If the unit has not been used for a long time, set it in the
playback mode to warm it up for a few minutes before you start
using it again.
On headphones/earphones
Road safety
Do not use headphones/earphones while driving, cycling, or
operating any motorized vehicle. It may create a traffic hazard
and is illegal in some areas. It can also be potentially dangerous to
play your headphones/earphones at high volume while walking,
especially at pedestrian crossings.
You should exercise extreme caution or discontinue use in
potentially hazardous situations.
Preventing hearing damage
Do not use headphones/earphones at high volume. Hearing
experts advise against continuous, loud and extended play. If you
experience a ringing in your ears, reduce the volume or
discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear
outside sounds and to be considerate to the people around you.
On maintenance
Clean the tape head and tape path using a cotton swab and
commercially available cleaning solvent after every 10 hours of
use.
•To clean the exterior, use a soft cloth slightly moistened in water.
Do not use alcohol, benzine or thinner.
•Clean the headphones/earphones plugs periodically.
A
AM
B C
FM
N PLAY**
M FF
m REW
VOL*
i
x STOP
ENTER
AM
FM
RADIO OFF
HOLD
MENU
SET
AA (R6) x 1
PRESET/TUNING +/–
* There is a tactile dot beside VOL on the main unit to show the direction to turn up the
volume.
** The button has a tactile dot.
Specifications
• Frequency range
FM: 87.5 - 108 MHz
AM: 530 - 1 710 kHz (North, Central and South America)
531 - 1 602 kHz (Other countries)
• Output
Headphone (i) jack
Load impedance 8 – 300
• Power requirements
1.5V DC, battery R6 (size AA) x 1
• Dimensions (w/h/d)
Approx. 83.6 x 112.0 x 28.3 mm (3
3
8
× 4
1
2
× 1
1
8
inches)
excl. projecting parts and controls
• Mass
Approx. 130 g (4.6 oz) (main unit only)
• Supplied accessories
Stereo headphones or Stereo earphones (1)
Carrying case with belt clip or Carrying pouch (1)
Design and specifications are subject to change without
notice.
Battery life* (approximate hours)
Sony alkaline LR6 (SG)** Sony R6P (SR)
Tape playback 35 9
Radio reception 40 14
* Measured value by the standard of JEITA (Japan Electronics
and Information Technology Industries Association). (Using
a Sony HF series cassette tape)
**When using a Sony LR6 (SG) alkaline dry battery (produced
in Japan).
Note
The battery life may be shorter depending on the operating
condition, the surrounding temperature and battery type.
Preparations
To Insert Battery A
1 Slide open the battery compartment lid, and
insert one R6 (size AA) dry battery with
correct polarity.
Replace the battery with new one when " " flashes
in the display.
Playing a Tape
1 Insert a cassette. B
2 Press N PLAY.
Adjust the volume with VOL.
To Press
Stop playback x STOP
Wind rapidly* M FF or m REW
* If you leave the unit after the tape has been wound or
rewound, the battery will be consumed rapidly. Be
sure to press x STOP.
Note
Do not open the cassette holder while the tape is
running.
“WALKMAN” is a registered trademark of Sony Corporation to
represent Headphone Stereo products.
is a trademark of Sony Corporation.