Filter
Top Products
Press (Beeps in the
headphones)
P on the remote
control (Continuous
short beeps)
Press P again to
resume play.
=or turn the
control to = on the
remote control once
(Three short beeps)
+ or turn the
control to (•+
on the remote control
once (Two short
beeps)
keep pressing
= or keep the
control turned to
=on the remote
control
keep pressing
+ or keep the
control turned to
(•+ on the
remote control
p and then OPEN
and open the lid.
2)
If the play does not start
Make sure the player is not locked. See “To
lock the controls.”
Display window while playing back
•Display window on the remote control
•Display window on the player
1) To go backwards or forward quickly without
listening, press P and keep pressing = or
+ (on the remote control, keep the control
turned).
2) Once you open the lid, the point to start play
will change to the beginning of the first track.
3) Appears only with MDs that have been
electronically labeled.
Note
Do not press OPEN during playback. If you do,
the lid opens and playback will stop.
When using optional headphones
Use the headphones that have stereo-miniplug.
You cannot use other types of headphones
(microplug).
Playing an MD right
away!
A
Before using the supplied rechargeable battery for the first time,
charge it. Other choices are dry batteries and house current (see
“Power sources”). The player automatically switches to play the stereo
or monaural sound according to the recorded sound.
Charge the rechargeable battery.
Install the supplied rechargeable battery NH-9WM(N) to the
supplied battery charger with correct polarity, and connect to a
wall outlet.
The charger lamp goes off when the charging has finished.
Full charging takes about 60 minutes.
Insert the rechargeable battery.
Insert an MD.
Caution
The use of optical instruments with this
product will increase eye hazard.
Information
IN NO EVENT SHALL SELLER BE LIABLE
FOR ANY DIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF ANY
NATURE, OR LOSSES OR EXPENSES
RESULTING FROM ANY DEFECTIVE
PRODUCT OR THE USE OF ANY
PRODUCT.
For Customers in the United States
Information
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, used, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Portable MiniDisc Player
Operating instructions
3-861-297-62(1)
1
MZ-E35
Sony Corporation ©1998 Printed in Japan
Welcome!
Welcome to the world of the MiniDisc! Here
are some of the capabilities and features
you'll discover with the new MiniDisc Player.
• Small body almost the size of a MiniDisc
jacket – Ideal weight and size; fits in your
shirt pocket.
• Shock-resistant memory offsets up to 40
seconds of optical read errors.
• Low power-consumption design enables
long playback with a single “chewing-gum
type” rechargeable battery.
• Shuttle dial remote control with LCD –
Keep the main unit in your pocket and
operate the MiniDisc player through the
shuttle dial on the remote control; The LCD
displays track information, playback mode
as well as battery condition.
To
Pause
Find the
beginning
of the current
track
Find the
beginning
of the next
track
Go backwards
while playing
1)
Go forward
while playing
1)
Remove
the MD
Track number
Track name
3)
or elapsed time of
the track being played
Track number
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
To avoid electrical
shock, do not open the
cabinet. Refer servicing
to qualified personnel
only.
For the customers in the U.S.A.
DISPOSAL OF NICKEL METAL HYDRIDE
BATTERY.
NICKEL METAL HYDRIDE BATTERY.
DISPOSE OF PROPERLY.
You can return your unwanted nickel
metal hydride batteries to your nearest
Sony Service Center.
Note: In some areas the disposal of nickel
metal hydride batteries in household or
business trash may be prohibited.
For the Sony Service Center nearest you
call 1-800-222-SONY (United States only)
Caution: Do not handle damaged or
leaking nickel metal hydride battery.
Owner's Record
The serial number is located inside the lid and
the model number is located at the top.
Record the serial number in the space
provided below. Refer to them whenever you
call upon your Sony dealer regarding this
product.
Model No. MZ-E35
Serial No. _______________________________
"MD WALKMAN" is a trademark of Sony
Corporation.
2 Insert an MD with the label facing up
and press the lid down to close.
1 Press OPEN and
open the lid.
3
2
2 Insert the battery with
correct polarity.
1 Slide open the battery
compartment lid like the
arrow in the illustration.
3 Press ( (turn the control to
(•+ on the remote control).
The player starts to play the first track.
If you use the remote control, a short
beep sounds in the headphones.
2 Connect the headphones with
remote control to 2/REMOTE.
4 Press VOL +/– to
adjust the
volume.
You can check the
volume in the
display of the
remote control.
1 Connect the headphones to
the remote control. Connect
it firmly all the way.
Play an MD.
4
To stop play, press p.
If you use the remote control, a short
beep sounds in the headphones.
VOL +/–
VOL +/–
p
Hold cover
lamp
NH-9WM(N)
(supplied)
}
]