Filter
Top Products
33
Receiving calls
When receiving a call, a ringtone is output from
your car speakers. The name and the phone
number appear in the display.
1 Press the multi way encoder when a
call is received with a ringtone.
The phone call starts.
Notes
• Only the phone number may appear, depending on
the cellular phone.
• The built-in microphone of this unit is located on the
rear of the front panel (page 15). Do not cover the
microphone with tape, etc.
Auto Answer setting
You can select an auto answer setting from “off,”
“Short” or “Long” (page 41).
Ringtone setting
You can switch the ringtone from “Default” or
“Cellular” (page 41).
* Depending on the cellular phone, this unit’s ringtone
may be output even if set to “Cellular.”
To reject a call
Press (SOURCE/OFF).
Operations during a call
Presetting the volume of the ringtone
and talker’s voice
You can preset the volume level of the ringtone
and talker’s voice.
To adjust the ringtone volume:
Rotate the multi way encoder while receiving a
call. “Ring Volume” appears and ringtone
volume can be adjusted.
To adjust the talker’s voice volume:
Rotate the multi way encoder during a call. “Talk
Volume” appears and the talker’s voice volume
can be adjusted.
Note
If the Bluetooth Phone source is selected, rotating the
multi way encoder will only adjust the talker’s volume.
EC/NC Mode (Echo Canceller/Noise
Canceller Mode)
You can reduce echo and noise.
Push the multi way encoder left/right to set to
“EC/NC Mode 1” or “EC/NC Mode 2.”
Note
Configurable during a call.
Sending DTMF (Dual Tone Multiple
Frequency) tones
You can send DTMF tones.
Press the required number buttons (0 – 9, or
) on the card remote commander to send
DTMF tones.
MIC Gain adjustment
You can adjust the volume for other party.
Push the multi way encoder up/down to adjust
the volume levels (“MIC Gain LOW,” “MIC
Gain MID,” “MIC Gain HI”).
Note
Configurable during a call.
Call transfer
To activate/deactivate the appropriate device (this
unit/cellular phone), check the following.
1 Press (MODE) or use your cellular
phone.
For details on cellular phone operation, refer to
your cellular phone manual.
Note
Depending on the cellular phone, handsfree
connection may be cut off when call transfer is
attempted.
Phonebook management
Notes on phonebook data
• Prior to disposal or changing ownership of your car
with this unit still installed, be sure to press the
RESET button to erase all the phonebook data in
this unit to prevent possible unauthorized access.
Disconnecting the power supply lead will also erase
all the phonebook data.
• Downloaded phonebook data from a cellular phone
cannot be overwritten by subsequent data. However,
some data (name, etc.,) may be duplicated as a
result.
• If you press the RESET button, the stored
phonebook data will be erased.
• Phonebook data may be lost if this unit is damaged.
• When disposing of this unit, phonebook data should
be deleted with “BT Initialize” (page 36).
• Up to 500 contacts can be stored in the phonebook.
If you try to register more than 500 contacts,
“Memory Full” appears.
continue to next page t