Open as PDF
Presetting Radio Stations
You can preset 20 FM stations, and 10 AM
stations. Before tuning, make sure to turn down
the volume to minimum.
1 Press BAND repeatedly until the band
you want appears in the front panel
Each time you press BAND, the band
toggles between AM and FM.
2 Press and hold TUNING + or – until
scanning starts, then release.
Scanning stops when the system tunes in a
station. “TUNED” and “ST” (for stereo
program) appear in the front panel display.
3 Press MEMORY.
A preset number appears in the front panel
4 Press PRESET + or – to select the
preset number you want.
5 Press ENTER.
The station is stored.
6 Repeat 1 to 5 to store other stations.
To change the preset number
Restart from step 1.
To change the AM tuning interval
The AM tuning interval can be set to either
9 kHz (default) or 10 kHz (for some areas).
To change the AM tuning interval, first tune in
any AM station, then turn off the system by
pressing "/1 on the remote, or "/1 on the
system. While holding down x (stop) (on the
system), press "/1 on the system to turn on the
power. If you change the interval, AM preset
stations will be erased.
To reset the interval, repeat the same procedure.
Enjoying the Radio