Sony CFD-E70L Clock Radio User Manual


 
28
GB
CD Player
no diSC lights in the display even when
a CD is in place.
Place the CD with the label surface up.
The CD-R/CD-RW was not finalized.
Finalize the CD-R/CD-RW with the
recording device.
There is a problem with the quality of the
CD-R/CD-RW, recording device, or
application software.
The CD does not play.
Place the CD with the label surface up.
Clean the CD.
Take out the CD and leave the CD
compartment open for about an hour to dry
moisture condensation.
The sound drops out.
Noise is heard.
Reduce the volume.
Clean the CD, or replace it if the CD is badly
damaged.
Place the player in a location free from
vibration.
The sound may drop out or noise may be
heard when using poor quality CD-Rs/CD-
RWs or if there is a problem with the
recording device or application software.
You cannot open/close the lid of the CD
compartment.
Place the player on a level surface and open/
close the lid.
Radio
The audio is weak or has poor quality.
Replace all the batteries with new ones if
they are weak.
Move the player away from the TV.
If you are using the remote while listening to
an AM (CFD-E75) or MW/LW (CFD-E70L/
E75L/E77L) radio, noise may be heard. This
is unavoidable.
The picture of your TV becomes unstable.
If you are listening to an FM programme near
the TV with an indoor antenna, move the
player away from the TV.
Tape Player
The tape does not move when you press
an operation button.
Close the tape compartment securely.
The REC z button does not function.
The tape does not play.
Make sure the safety tab on the cassette is in
place.
The tape does not erase completely.
Clean the erasing head (see page 30).
Replace all the batteries with new ones if
they are weak.
The source which was recorded on TYPE II
(high position) or TYPE IV (metal) tape
using this unit is being played. Record on
TYPE I (normal) tape and play.
The tape does not record.
Make sure the tape is inserted properly.
Make sure the safety tab of the cassette is in
place.
The audio is weak.
The audio quality is poor.
Clean the heads, pinch roller and capstan (see
page 30).
Demagnetize the heads using a demagnetizer
(see page 30).
The sound is distorted.
The TYPE II (high position) or TYPE IV
(metal) tape is being used. Use TYPE I
(normal) tape only.
Troubleshooting (continued)