Samsung DVD-HR720 MP3 Player User Manual


 
English - 39
System Setup
DTS
1. Off : Doesn’t output DTS signal. Select this
when your AV receiver or AV amplifier
does not have DTS decoder.
2. On : Outputs DTS Bitstream via digital output
when you play DTS track. Select this only
when your AV receiver (or AV amplifier)
have DTS decoder.
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. On : When Movie soundtracks are played at
low volume or from smaller speakers, the
system can apply appropriate
compression to make low-level content
more intelligible and prevent dramatic
passages from getting too loud.
2. Off : You can enjoy the movie with the
standard Dynamic Range.
Digital Output
1. PCM : Select this when you have no
equipment that can decode Dolby
Digital (or MPEG-2) signal. When you
play Dolby Digital (or MPEG-2) sound
track, the digital output are converted to
PCM Stereo.
2. Bitstream : Output Dolby Digital (or MPEG-2)
audio as bitstream. Select this
when your AV receiver or AV
amplifier have Dolby Digital (or
MPEG-2) Decoder.
Digital output setting is equally applied to
both Dolby Digital and MPEG-2 audio.
LPCM sound track is always outputted as
PCM. It has no relation with Digital
Output setting.
Be sure to select the correct Digital
Output or you will hear no sound or loud
noise.
NOTE
When DTS soundtrack is played, sound
does not output from AV Audio Output.
NOTE
3-HR720-XAC_26-44_SETUP 5/17/05 9:55 PM Page 39