RCA RP5412 Clock Radio User Manual


 
Setting Clock
Turn the clock setting knob on the back
of the unit to adjust clock time. The time
decrements or increments will follow by a
faster rate when you push and hold the
knob. A clock icon flashes on the display
while you are adjusting the time.
Selecting between Analogue
and Digital Clock
Press display to select between analgoue
and digital clock display.
Before You Begin
General Controls
General Controls Clock
Important InformationFCC Information Safety Information
English
Radio
It is important to read this instruction book prior to using your new product for the first time.
RP5412/5414
user
manual
WARNING:
TO PREVENT FIRE
OR ELECTRICAL
SHOCK HAZARD,
DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
SEE MARKING ON BOTTOM / BACK OF PRODUCT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE EXCLAMATION
POINT WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
THE LIGHTNING
FLASH AND ARROW-
HEAD WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
"DANGEROUS
VOLTAGE" INSIDE
THE PRODUCT.
CAUTION: TO REDUCE THE
RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER
(OR BACK). NO USER-
SERVICEABLE PARTS IN-
SIDE. REFER SERVICING
TO QUALIFIED SERVICE
PERSONNEL.
GEFAHR EINES 
ELEKTRISCHEN SCHLAGS
Wake Function
Setting Wake Time
This unit allows two wake times to be set.
Turn the wake time setting knob WAKE
or WAKE on the back of the unit to
adjust wake time 1 and 2 respectively .
The time decrements or increments will
follow by a faster rate when you push and
hold the knob. “WAKE 1” or “WAKE 2”
icon flashes on the display while you are
adjusting respective wake time.
Selecting Wake Source
You may be woken up by radio or alarm.
1. Select an AM or FM station (see
directions on “Radio”).
2. Set a wake time (see above direction).
3. Slide the switch WAKE 1 or WAKE 2
on the sides of the unit to /
(wake by alarm) or / (wake by
radio). Corresponding icon lights on
the front of the unit.
- Wake 1 by alarm
- Wake 1 by radio
- Wake 2 by alarm
- Wake 2 by radio
Checking Wake Time
Press WAKE 1 CHECK TIME or WAKE 2
CHECK TIME on the sides of the unit to
check respective wake time. Wake time
shows briefly on the display.
EN/F/E
FCC Information
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
In accordance with FCC requirements, changes
or modifications not expressly approved by
Thomson Inc. could void the user’s authority to
operate this product.
This device generates and uses radio frequency
(RF) energy, and if not installed and used
properly, this equipment may cause interference
to radio and television reception.
If this equipment does cause interference to
radio or television reception (which you can
determine by unplugging the unit), try to correct
the interference by one or more of the following
measures:
• Re-orient the receiving antenna (that is, the
antenna for the radio or television that is
“receiving” the interference).
• Move the unit away from the equipment that
is receiving interference.
• Plug the unit into a different wall outlet so
that the unit and the equipment receiving
interference are on different branch circuits.
If these measures do not eliminate the
interference, please consult your dealer or an
experienced radio/television technician for
additional suggestions. Also, the Federal
Communications Commission has prepared a
helpful booklet, “How To Identify and Resolve
Radio TV Interference Problems.” This booklet
is available from the U.S. Government Printing
Office, Washington, DC 20402. Please specify
stock number 004-000-00345-4 when ordering
copies.
EXPORTER
Thomson Inc.
P. O. Box 1976
Indianapolis, IN 46206 - 1976
©2006 Thomson Inc.
Trademark(s) ® Registered
Marque(s) ® Deposée(s)
Marca(s) ® Registrada(s)
www.rca.com
Printed in China / Impreso en China
5629 7750 (EN/F/E)
IMPORTADOR
Comercializadora Thomson de México, S.A. de C.V.
Álvaro Obregón No. 151. Piso 13.
Col. Roma. Delegación Cuauhtémoc
C.P. 06700. México, D.F.
Telefono: 52-55-11-020360
RFC: CTM-980723-KS5
For Your Safety
The AC power plug is polarized
(one blade is wider than the
other) and only fits into AC
power outlets one way. If the
plug will not go into the outlet
completely, turn the plug over
and try to insert it the other
way. If it still does not fit, contact a qualified
electrician to change the outlet, or use a
different one. Do not attempt to bypass this
safety feature.
For Your Records
In the event that service should be required, you
may need the model number. In the space
below, record the date and place of purchase:
Date of Purchase:
Place of Purchase:
Service Information
This product should be serviced only by those
specially trained in appropriate servicing
techniques. For instructions on how to obtain
service, refer to the warranty included in this
Guide.
Technical Information
Product: Clock Radio
Brand: RCA
Model: RP5412/RP5414
Electrical Consumption
Power Supply: 120V ~ 60Hz
Power Consumption: 5 Watts
IMPORTER
Comercializadora Thomson de México, S.A. de C.V.
Álvaro Obregón No. 151. Piso 13.
Col. Roma. Delegación Cuauhtémoc
C.P. 06700. México, D.F.
Telefono: 52-55-11-020360
RFC: CTM-980723-KS5
The descriptions and characteristics in this owner’s manual are for the purpose of general reference only and not
as a guarantee. In order to provide you with the highest quality product, we may make changes or modifications
without prior notice. The English version serves as the final reference on all product and operational details
should any discrepancies arise in other languages.
Make sure that you keep your set
away from water and high
temperatures.
• Do not use your System immediately
after transporting it from a cold place
to a warm place, as condensation may
cause the system to malfunction.
• Keep your unit away from humid
areas and abnormally hot places.
• To prevent personal injury, do not
reverse any batteries.
The use of apparatus in moderate
climates.
The apparatus shall not be exposed to
dripping or splashing and that no
objects filled with liquids, such as
vases, shall be placed on the
apparatus.
No naked flame sources, such as
lighted candles, should be placed on
the apparatus.
Attention should be drawn to the
environmental aspects of battery
disposal.
Minimum distances (2cm) around the
apparatus for sufficient ventilations.
The ventilation should not be
impeded by covering the ventilation
opening with items, such as
newspaper, table-cloths, curtains, etc.
The rating plate is located at the
bottom cabinet of apparatus.
Ecology
Help protect the environment - we
recommend that you dispose of used
batteries by putting them into specially
designed receptacles.
Maintenance
Clean the unit with a soft cloth, or a damp
chamois leather. Never use solvents.
Power Failure Indicator
When AC power is interrupted (disconnected)
for a short period of time, both time and
alarm settings will change (unless battery is
installed). After AC power is restored
(reconnected), the Digital Display will blink to
indicate that power was interrupted and you
should readjust the time and alarm settings.
Plugging In For Power
AC OUTLET POWER SUPPLY:
120V~60Hz
Note:Note:
Note:Note:
Note:
Power is fed to the unit even
when it is not functioning. To cut
the power supply off, the power cable
must be unplugged.
Front View
power switch - turns the unit on or off.
Left View
BAND/FM••AM - selects FM or AM band.
TUNING - selects radio frequency.
WAKE 1 - activates Wake 1 settings and
changes Wake 1 mode.
(Wake to alarm) - selects alarm as the
waking mode.
(Wake to music) - selects radio as the
waking mode.
OFF - deactivates Wake 1 waking mode.
WAKE 1 CHECK TIME - press once to check
waking time.
Right View
BRIGHTNESS/LO••HI - selects display
brightness (LO - low, HI - high)
-VOLUME+ - adjusts volume.
WAKE 2 - activates Wake 2 settings and
changes Wake 2 mode.
(Wake to alarm) - selects alarm as the
waking mode.
(Wake to music) - selects radio as the
waking mode.
OFF - deactivates Wake 2 waking mode.
WAKE 2 CHECK TIME - press once to check
waking time.
Top View
display - switches between analogue and
digital clock display.
SNOOZE - turns off the alarm.
sleep - activates sleep function.
Back View
WAKE - adjusts Wake 1 time.
- adjusts clock time.
WAKE - adjusts Wake 2 time.
Before You Plug for Power
1. Setting Time Zone
You may slide the time zone selector at
the bottom of the unit to Eastern,
Central, Mountain or Pacific. (refer to the
maps on the right)
2. Day Light Saving
You can slide the day light saving switch
at the bottom of the unit to turn on/ off
in areas observing/ not observing such
time change.
WARNING: Please avoid playing with
these buttons after entering the
Clock/Alarm set mode.
Auto Clock Set
You do not have to set the clock time as a
built-in automatic time set system is
equipped in this clock powered by 3V (2
X AA batteries (included). All you have to
do is to plug this clock for power and
current time will be shown automatically.
However, the batteries can also be
exhausted and we recommend that you
replace the batteries every 2-3 years.
Display Brightness
Clock time and radio frequency are
display on the display area at the front of
the unit. You can adjust the brightness of
the display by sliding BRIGHTNESS/
LO••HI on the right of the unit.
Switching Band
Slide the BAND/FM•AM switch on the left
of the unit to select FM or AM band.
Tuning the Radio
Turn the TUNING knob on the left of the
unit to adjust radio frequency.
FM Antenna
The FM antenna cord is attached at the
back of the unit. We recommend the cord
be fully extended for best FM reception.
Built-In AFC
The Built In Automatic Frequency Control
(AFC) works only on FM. It helps reducing
drift on FM reception and keeping the
radio locked in on the FM station to which
it is tuned.
When tuning in FM stations, you may notice
that the station you are tuning can
be well-tuned on two or three nearby
points on the dial. Always tune carefully
at the loudest and clearest point.
AM Antenna
A built-in ferrite rod antenna eliminates the
need for an outside antenna for AM
reception. Rotating the unit slightly may
improve reception of distant AM stations.
Wake Function
Tip: The unit equips with
GRAD-GRAD-
GRAD-GRAD-
GRAD-
U-WAKE U-WAKE
U-WAKE U-WAKE
U-WAKE feature, the alarm tone
volume will increase gradually to
its maximum in about 30 to 45
seconds.
Turning Off the Wake Alarm or
Radio
Press SNOOZE on the top of the unit. The
wake alarm or radio will be switched off
temporarily. The alarm or radio will be on
again when the snooze period is over. (see
“SmartSnooze
TM
Operation”)
To turn off the wake alarm or radio
completely, press . The wake alarm or
radio will activate again the next day unless
you switch off the Wake function (see
“Switching off Wake Function”).
SmartSnooze
TM
Operation
This operation allows extra sleep time
after the wake function is on. The alarm
will be off by pressing SNOOZE, sleep or
display until the snooze period is over.
Snooze function can be used repeatedly
up to 30 minutes. After this, the wake
function will turn off until the next day.
Set the “quiet” period as follow:
1. Press and hold SNOOZE.
2. Turn the clock setting knob on the
back of the unit to adjust the snooze
“quiet” period. The time decrements
or increments will follow by a faster
rate when you push and hold the
knob.
Switching Off Wake Function
Slide the switch WAKE 1 or WAKE 2 on the
sides of the unit to OFF to switch off
respective wake function. The set wake time
will not be erased and can be used the next
day when you switch on wake function again.
Sleep Function
In sleep mode, you can set the duration
(up to 2 hours) before the radio turn off
automatically.
1. Press and hold SLEEP and turn the
clock setting knob on the back of
the unit to adjust the duration up to 2
hours. The time decrements or
increments will follow by a faster rate
when you push and hold the knob.
Note: The radio will be switched on.
2. To check the remaining duration before
the radio turns off, press and hold SLEEP.
3. To cancel the sleep function, press
SNOOZE or power switch.
Wake Function
Clock
US Time Zones
Canadian Time Zones
Bottom View
Time zone selector - selects time zone.
Daylight saving switch - switches day light
saving time on or off.
Battery Back-Up Operation
This clock radio is equipped with a
memory holding system that can be
powered with 2 “AA” batteries (included).
The power failure protection circuit will
not operate unless battery is installed.
When normal household power is
interrupted, or AC line cord is unplugged,
the batteries will power the clock radio to
keep track of time and alarm settings
programmed into memory. When the
battery backup functions, the digital
display will not light, however, the
function of alarm still occurs during the
power interruption if remaining battery
power is adequate. Normal operation will
resume after AC power is restored so you
will not have to reset the time or the
alarm.
Install batteries as follow:
1. Remove battery compartment door
(located at the bottom of the radio)
by applying thumb pressure to the
tab on battery door and then lift the
door out and off the cabinet.
2. Insert 2 AA batteries (included).
3. Replace the compartment door.
Note: we recommend that you replace the
batteries every 2-3 years.