RCA 7-4825 Clock Radio User Manual


 
We bring good things to life.
Dual Wake Clock Radio
User’s Guide
7-4825
FOR YOUR SAFETY
The AC power plug is polarized (one blade is wider than the other) and
only fits into AC power outlets one way. If the plug won’t go into the
outlet completely, turn the plug over and try to insert it the other way. If it
still won’t fit, contact a qualified electrician to change the outlet, or use a
different one. Do not attempt to bypass this safety feature.
IMPORTANT BATTERY INFORMATION
When storing or unplugging from AC outlet for a day or more, be sure
to remove battery because it can leak and damage the unit.
Batteries may leak electrolyte if inserted incorrectly, if disposed of in
fire, or if an attempt is made to charge a battery not intended to be
recharged.
Discard leaky batteries immediately. Leaking batteries can cause skin
burns or other personal injury.
Dispose of batteries, according to federal, state, and local regulations.
SERVICE
This product should be serviced only by those specially trained in
appropriate servicing techniques. Attach your sales receipt to the booklet
for future reference or jot down the date this product was purchased or
received as a gift. This information will be valuable if service should be
required during the warranty period.
Purchase Date _________________________
Name of Store ________________________
WARNING:
TO PREVENT FIRE
OR ELECTRICAL SHOCK HAZARD,
DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
SEE MARKING ON BOTTOM / BACK OF PRODUCT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE EXCLAMATION
POINT WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
THE LIGHTNING
FLASH AND ARROW-
HEAD WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
"DANGEROUS
VOLTAGE" INSIDE
THE PRODUCT.
CAUTION: TO REDUCE THE
RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER
(OR BACK). NO USER-
SERVICEABLE PARTS IN-
SIDE. REFER SERVICING
TO QUALIFIED SERVICE
PERSONNEL.
Model 7-4825
15308460 (Rev. 1 E/S)
98-00
Printed in China
P.O. Box 1976, Indianapolis, IN 46206
© 1998 Thomson Consumer Electronics, Inc.
Trademark(s) ® Registered
Marca(s) Registrada(s)
“NO WORRY” BATTERY BACKUP
This clock radio is equipped with a memory holding system powered by a
9-volt alkaline battery (not included).
When power is interrupted or the AC line cord is unplugged, the battery
will power the clock radio to keep track of time and alarm settings
programmed into memory. Should WAKE TIME occur during the power
interruption, the radio will operate or the alarm will sound if remaining
battery power is adequate. Normal operation will resume after AC power
is restored. When on battery power, the digital display will not light.
Install battery as follows:
1. Unlatch and lift off battery compartment door (located on bottom of
radio).
2. Connect a 9-volt battery.
3. Insert battery in compartment and replace compartment door.
BUILT-IN AFC
The Built-In Automatic Frequency Control (AFC) works only on FM. It
helps keep the radio locked on the FM station to which it is tuned.
When tuning in FM stations, you may notice that often the station you
desire can be heard on two or three nearby points on the dial. Always
tune carefully to the loudest and clearest point.
ANTENNAS
AM Antenna - A built-in ferrite rod antenna eliminates the need for an
outside antenna for AM reception - Rotating the unit slightly may improve
reception of distant AM stations.
FM Antenna - The power cord acts as your FM antenna. The power cord
picks up moderate to strong stations and eliminates the need for an
external antenna in most strong signal areas. Be sure the power cord is
stretched to its full length. Do not coil or bunch the cord together.
Changing position of the power cord may improve reception.
OPERATING THE RADIO
1. Plug the power cord into any 120V AC household outlet.
2. Press the ON button.
3. Slide the AM/FM BAND switch to desired broadcast band.
4. Turn TUNING dial to select a station and then turn the VOLUME
control to your preferred listening level.
5. Press the OFF button to turn radio off.
SETTING THE TIME
Use the FAST FORWARD, FORWARD and REVERSE buttons to set the
correct time. The AM indicator to the left of the digital display will show
when the clock is reading AM time.
SETTING THE WAKE TIME
You can select two different wake times for music or alarm to turn on
automatically. WAKE 1 and 2 controls are located on top of the unit
behind the SNOOZE bar.
1. Slide switch to SET position. The display will change to wake time.
2. Use the FAST FORWARD, FORWARD and REVERSE buttons as needed
until you reach your desired AM or PM wake time.
For music, select an AM or FM station and then turn the radio off. Set
wake time and then slide the switch to MUSIC. For Alarm, set wake time
and then slide switch to ALARM position.
If a wake time is set, an indicator in the display lights and the unit turns
on in the chosen mode (alarm or music) at the set time for approximately
one hour. To turn off the wake mode, slide the switch to OFF or press the
OFF button.
NOTE: If both Wake 1 and Wake 2 controls are in the SET position,
the time of day is displayed.
USING SNOOZE CONTROL
After the wake mode has activated, you can silence it for another 7
minutes by pressing the SNOOZE button. When the wake mode activates
again, you can turn the unit off or use SNOOZE button for up to 59
minutes. The radio or alarm will then turn itself off after about an hour.
SLEEP TO MUSIC
You can drift off to sleep to music knowing that the radio will turn itself off
automatically.
1. Turn the radio off.
2. Press and hold the SLEEP button. The radio will turn on
automatically
and 0:59 will show in the display.
3. Hold down the SLEEP button until you reach a sleep time between
59 and 1 minute.
The radio will play for the chosen length of time (up to 59 minutes)
and then turn itself off. If you decide to turn the radio off before the
total number of minutes have passed, just press the OFF button.
POWER FAILURE INDICATOR
If AC power is interrupted (disconnected) for a short period, both time
and alarm settings will change unless optional battery is installed. After
AC power is restored (reconnected) the digital display will blink to
indicate that power was interrupted and you must readjust the TIME and
ALARM settings.
FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
In accordance with FCC requirements, changes or modifications not
expressly approved by Thomson Consumer Electronics could void the
user’s authority to operate this product.
This device generates and uses radio frequency (RF) energy, and if not
installed and used properly, this equipment may cause interference to
radio and television reception.
If this equipment does cause interference to radio or television reception
(which you can determine by unplugging the unit), try to correct the
interference by one or more of the following measures:
Reorient the receiving antenna (that is, the antenna for the radio or
television that is “receiving” the interference).
Move the unit away from the equipment that is receiving interference.
Plug the unit into a different wall outlet so that the unit and the
equipment receiving interference are on different branch circuits.
If these measures do not eliminate the interference, please consult your
dealer or an experienced radio/television technician for additional
suggestions. Also, the Federal Communications Commission has pre-
pared a helpful booklet, “How To Identify and Resolve Radio TV Interfer-
ence Problems.” This booklet is available from the U.S. Government
Printing Office, Washington, DC 20402. Please specify stock number 004-
000-00345-4 when ordering copies.
LIMITED WARRANTY
What your warranty covers:
Any defect in materials or workmanship.
For how long after your purchase:
One year.
(The warranty period for rental units begins with the first rental or 45 days from date
of shipment to the rental firm, whichever comes first.)
What we will do:
Provide you with a new or, at our option, a refurbished unit.
The exchange unit is under warranty for the remainder of the original product’s
warranty period.
How to make a warranty claim:
Properly pack your unit. Include any cables, etc., which were originally provided with
the product. We recommend using the original carton and packing materials.
Remove cassette tapes or CDs from unit before shipping as these will not be
returned.
Include in the package evidence of purchase date such as the bill of sale. Also print
your name and address and a description of the defect. Send standard UPS or its
equivalent to:
Thomson Consumer Electronics, Inc.
Product Exchange Center
32 Spur Drive
El Paso, Texas 79906
Pay any charges billed to you by the Exchange Center for service not covered by the
warranty.
Insure your shipment in case of loss or damage. Thomson accepts no liability in case
of damage or loss.
A new or refurbished unit will be shipped to you prepaid freight.
What your warranty
does not
cover:
Customer instruction. (Your Owner’s Manual provides information regarding
operating instructions and user controls. For additional information, ask your dealer.)
Installation and set-up service adjustments.
Batteries.
Damage from misuse or neglect.
Products which have been modified or incorporated into other products.
Products purchased or serviced outside the USA.
Acts of God, such as but not limited to lightning damage.
Product Registration:
Please complete and mail the Product Registration Card packed with your unit. It will
make it easier to contact you should it ever be necessary. The return of the card is not
required for warranty coverage.
How state law relates to this warranty:
This warranty gives you specific legal rights, and you may have other rights which
vary from state to state.
If you purchased your product outside the USA:
This warranty does not apply. Contact your dealer for warranty information.
NOTE:
• Alkaline batteries are recommended. Carbon-zinc batteries may be
used but memory holding time will be substantially reduced. Memory
holding time for a fresh alkaline battery is approximately 8 hours (if
Wake System is not activated). To preserve battery life, the radio
should remain plugged into an AC outlet. As the battery gets older, its
voltage will drop and memory may be lost. Be sure to replace the
battery periodically.
• Be sure to remove battery when storing the unit. Battery will be
drained if left connected while the unit is unplugged, and a worn out
battery may leak chemicals which can badly damage the clock radio.
When discarding batteries, be sure to dispose of them in the proper
manner, according to your state and local regulations.
WAKE 1 Switch
WAKE 2 Switch
OFF/RESET
Button
SLEEP Button
ON Button
SNOOZE
Control
TIME SET buttons
• REW
• FWD
• FFWD
Band Switch
• AM
•FM
Volume
Tuning
RADIO
OFF
ON
SLEEP
REV
ON
F/FWD
FWD
TIME SET
WAKE 2
MUSIC ALARM SETOFF
WAKE 1
MUSIC ALARM SETOFF
S N O OZ E
FM AM