-
6
-
LCD INSTRUCTION
1. TOTAL TRACK – the track number of the CD or CARD.
2. – The unit is in playing.
3. – The unit is paused
4.
SINGLE –
Shows when the unit is set to play only one track.
5. CONT – Shows when the unit is set to play the all tracks
continually.
6.
OUTRO –
Shows when the unit is set to play the last 30
seconds of each track.
7.
MP3 –
Lights up when the unit is playing MP3 file.
8.
TIME MODE (ELAPSED) –
Shows the time as it is taking
place.
9.
TIME MODE(TOTAL) –
Shows how much time is left on
full CD, but not for MP3 CD.
10. TIME MODE (REMAIN) – Shows how much time is left on
a particular track.
11. – A1 lights up after setting up start point(A point). A1 and
flash after setting end point (B point) and
start the loop playback automatically. A1 and
light up after exiting the LOOP playback and
in performance.
12. – Refer to SEAMLESS LOOP A1.
13.
TIME BAR –
Show the time length depending on the setting
of the “TIME” mode.
14.
TRACK –
Shows the track number that is playing.
15. MINUTES – Shows the minutes elapsed or remaining
depending on mode setting.
16.
SECONDS –
Shows the seconds elapsed or remaining
depending on mode setting.
17.
FRAMES –
The CD Player breaks down a second into 75
frames for accurate cueing. This shows the frames
elapsed or remaining depending on mode setting.
18.
EFFECT MODE DISPLAY –
Shows the effect name
selected in effect parameter setting mode and
shows the song name in performance.
19. THE PARAMETER OF SOUND EFFECT
20.
PITCH –
The pitch change range
21.
KEY –
Lights up when key effects are active and indicates key
position, otherwise it flash.
22. – Lights up when key has been locked.
23. BPM: Manual ; BPM : Auto
24. Number of Beat per minute
25.
CARD
– Lights up when the unit is reading SD card.
(OPTION FUNCTION)
26. EFFECT – Lights up when the EFFECT function is on.
27.
+10 –
Lights up and indicate the scope value of effect
parameter to be adjusted 10 units each time.
28.
LOADING MP3:
During writing data to the card, It will
show ”PC LINK”. (OPTION FUNCTION)