Filter
Top Products
5 Press SOURCE and hold until the unit
turns off.
6 Press OPEN to open the front panel.
7 Press and hold AUDIO to enter the auto
TA and EQ measurement mode.
8 Plug the microphone into the micro-
phone input jack on this unit.
9 Press a to start the auto TA and EQ.
10 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about six minutes.
# To stop auto TA and EQ, press any buttons
other than BAND.
# To cancel auto TA and EQ part way through,
press BAND.
11 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 63.)
12 Press BAND to cancel the auto TA and
EQ mode.
13 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunction.
Note
Make sure you have disconnected the micro-
phone before pressing OPEN to open or close the
panel (an alert sounds if the mic is still con-
nected).
Audio Adjustments
En
53
English
Section
08