Filter
Top Products
±0 24 is displayed as the level is increased
or decreased.
+6 24 is displayed as the level is increased
or decreased, only if you have selected
Low LPF.
6 Press AUDIO to select NW.3.
Press AUDIO until NW.3 appears in the dis-
play.
7 Press c or d to select the slope of the
selected speaker unit (filter).
Each press of c or d selects slopes in the fol-
lowing order:
Low LPF: 36 30 24 18 12 (dB/
oct.)
Mid HPF: 24 18 12 6Pass (0)
(dB/oct.)
Mid LPF: 24 18 12 6Pass (0)
(dB/oct.)
High HPF: 24 18 12 6 (dB/oct.)
8 Press AUDIO to select NW.4.
Press AUDIO until NW.4 appears in the dis-
play.
9 Press c or d to select the phase of the
selected speaker unit (filter).
Press c to select reverse phase and Reverse
appears in the display. Press d to select nor-
mal phase and Normal appears in the display.
# You can adjust the parameters for other
speaker units (filters) in the same way.
10 Press BAND to cancel the network ad-
justment mode.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Press AUDIO to select SW.1.
Press AUDIO until SW.1 appears in the dis-
play.
2 Press a to turn subwoofer output on.
SW : ON appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and Reverse
appears in the display. Press d to select nor-
mal phase and Normal appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO to select SW.2.
Press AUDIO until SW.2 appears in the dis-
play.
# When the subwoofer output is on, you can se-
lect SW.2.
2 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125160200 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6 24 is dis-
played as the level is increased or decreased.
Audio Adjustments
En
46
Section
08