Open as PDF
This portable DVD player is designed with a
built-in lithium battery to supply power to the
player when you are on travel.
1 Slide the POWER switch to the OFF position
(charging of the DVD player only possible in
the power-off mode).
2 Connect the supplied power adaptor cord (or
the car adaptor) to the player and AC mains
(or the car cigarette lighter outlet) to start
➜ The CHG indicator turns red .
➜ When the battery is fully charged, the
indicator turns off.
3 Disconnect the power adaptor cord (or the
car adaptor) when the CHG indicator turns
– You can also connect the supplied power adaptor
cord (or the car adaptor) to the player and AC
mains (or the car cigarette lighter outlet) directly
Charge your battery
Quick start guide
Philips Portable DVD Player PET722/PET726
3 OPEN HERE
1 Slide the POWER switch to ON to switch on
the DVD player.
➜ The POWER indicator turns on.
2 Gently push the front panel as shown to open
the disc compartment.
4 Remove the protective card (if any) and load a
disc with the label side facing up.
5 Pull the front panel back to close the disc
compartment. Playback will start automatically.
If not, press 2; .
6 To stop playback, press 9.
Enjoy (Disc operation)
– Once the battery is fully discharged, immediately
recharge it (regardless of whether you plan to use
the battery or not) in order to maximize the
battery life.When the power is low, the battery icon
will be shown on the upper-left corner of the TFT
Enjoy (AV OUT)
Connecting additional equipment (TV for
1 Connect the AV OUT socket on the set to the
video and audio sockets on a TV as shown
2 Switch on the TV and set to the correct video-
➜ You can consult the owner's manual of your
TV. (If your TV does not have Audio and Video
inputs, you will need to purchase a RF
modulator. Please consult your dealer.)
PET722-Eng_QSG.qxd 2008.1.3 16:22 Page 1