Filter
Top Products
12
English
Radio Reception
Tuning to radio stations
1 Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source (FM).
2 Hold S / T on the system (or TUNING
+/- on the remote control) and then release the
button.
➜ The system will start searching for a radio
station with sufficient signal strength.
3 Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press S / T on
the system (or TUNING +/- on the remote
control) briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
(40 FM) in the memory.
Automatic programming
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be erased.
● Press PROG on the remote control for more
than two seconds to activate programming.
➜ All available stations are programmed.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROG on the remote control to activate
programming.
➜ PROG appears in the display.
3 Press PRESET +/- on the system (or ALBUM/
PRESET 3 / 4 on the remote control) to
allocate a number from 1 to 40 to this station.
4 Press PROG on the remote control again to
confirm the setting.
➜ PROG disappears, the preset number and
the frequency of the preset station are shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESET +/- on the system (or ALBUM/
PRESET 3 / 4 on the remote control) until
the desired preset station is displayed.
pg001-021_DC910_98_Eng 8/5/08, 15:4912