Filter
Top Products
C679M (5/02)
DX9000 Series Video Storage Unit
Optional Sliding Support Rails
®
If your DX9000 Series Video Storage Unit includes optional sliding support rails, follow the in-
structions below for installing them.
The equipment rack must have two sets of mounting rails at the front and back of the rack (items
1B and 3B in Figure 1).
WARNING:
Because the storage unit is extremely heavy, the equipment rack
must be anchored to the floor to prevent the rack from toppling when the storage
unit is pulled out on the sliding support rails. The support rails must be attached to
the storage unit to provide adequate support when the storage unit is mounted in the
equipment rack. Attaching the storage unit to the equipment rack with just the rack ears
may damage the equipment rack.
ᕡ Attach the support rails to the equipment rack as follows:
a. Attach two brackets to each support rail with the supplied hardware.
b. Fasten the brackets to the inner sides of the equipment rack mounting rails (hardware
not supplied).
ᕢ Unlock the disk trays in the unit by turning the key clockwise. Remove the disk trays from
the storage unit. To remove a disk tray, pull the trigger on the underside of the handle and
pull the disk tray out.
ᕣ Attach the storage unit to the equipment rack as follows:
a. Slide out the inner piece of each support rail. Attach the storage unit to the inner
pieces with the supplied hardware.
b. Push the storage unit into the equipment rack. Fasten the rack ears to the equipment
rack with the four 10-32 x .750-inch, black, Phillips, pan head screws that are supplied
with the storage unit.
ᕤ Install the disk trays in the correct slots. Trays with hard disk drives installed in them have
the slot number listed on the top slide rail. Trays without hard disk drives can be installed in
any remaining slots.
SLOT 10
SLOT 9
SLOT 8
SLOT 7
SLOT 6
SLOT 5
SLOT 4
SLOT 3
SLOT 1
SLOT 2
DISK TRAYS
4
2
AND LOCK
3A
1A
1B
1A
3B
1B
Figure 1. Installation of Sliding Rails
Pelco World Headquarters
3500 Pelco Way
Clovis, CA 93612-5699
USA
USA & Canada
Tel: 800/289-9100
Fax: 800/289-9150
International
Tel: 1-559/292-1981
Fax: 1-559/348-1120
www.pelco.com