Filter
Top Products
53
For Your Information
Before Requesting Service
If a problem should arise, you may be able to correct it yourself using the corrections
listed below. If the problem persists, contact your nearest Servicenter.
Unit does not power up...
Power is on, but unit turns off
after a short period...
Power turns off automatically...
Unit will not turn off...
Copying cannot be performed...
Files and folders cannot be
located...
• Be sure the battery and AC adaptor are
connected properly.
• Use a fully recharged battery.
• Press STANDBY for at least 2 seconds.
• Use a fully recharged battery.
• Always recharge battery within specified
temperature range. Battery will not recharge
at low temperatures under 23 F (-5 °C).
• If powering unit with battery only, power will shut
off if no operation is performed for 5 minutes.
Turn unit back on.
• Power will not turn off while files are being read
or copied. Turn unit off after SD/HDD access
Lamp goes out.
• Power will not turn off when HDD SAFETY
Detection Switch is activated. Place unit on flat,
level surface, then turn off the power.
• Insert card correctly.
• Be sure copy destination has sufficient free
space. Delete unnecessary data to free up
space.
• If HDD SAFETY Detection Switch was
activated, place unit on flat, level surface.
• Secure data files (audio files that include
copyright restrictions) cannot be copied.
• If the SD Memory Card write-protect switch is
set to “LOCK”, data cannot be overwritten.
• In Copy or TV mode, when an SD Memory Card
is copied to a PC Card HDD, copied data will be
placed in a folder entitled, “CARD****”. Open this
folder and confirm data was copied.
• If all or selected data in a “CARD****” folder is
copied to an SD Memory Card, the “CARD****”
folder disappears and data is copied according
to file structure rules. See “Copying and
Backup” section on page 12.
Symptom Correction
(Continued on next page.)
PT1.p50-56.p65 2003/01/14, 12:3753