Filter
Top Products
44
PC Mode (Operation with the PC)
M
C
A
N
C
E
L
E
N
U
/SET
SET
1 Make connections following “Setup (Connections)” steps on page 42.
2 Select and change to another card.
• With a USB cable connected, selecting another card will terminate
communication with the PC. Do Steps 1~4 of “Disconnecting Unit from PC” on
page 45, then proceed with the following operation.
Press to select “SD” or “HDD (PC Card)”,
then press SET.
• While the SD or HDD lamp is flashing, “CANNOT
CHANGE SLOT” is displayed and operation is not
possible. After the lamp goes out, press SET again.
File Operations
When this unit is connected to a PC using the USB Cable provided (p. 42), it will be
recognized as a Removable Disk. You can then copy, move, delete, and display files
on this unit the same as with a normal disk drive.
HDD Lamp
SD Lamp
• Drive letters (e.g. “H:”) and method of opening My Computer may vary depending on the PC.
• With USB cable connected, the “Removable Disk” icon will not appear while the SD or HDD
Lamp flashes as the PC checks the connection. Check for the icon once the indicator goes
out. It may take several minutes for the PC to recognize the PC Card HDD device.
– Note –
Liquid Crystal
Display
(Liquid Crystal Display)
3 Double-click [My Computer], then
double-click [Removable Disk].
• Files contained on the card will be
displayed and normal PC operations can
be done.
• If no removable disk is found, refer to
“Reinstalling the Device Driver” on page 48.
PT1.p42-45.p65 2003/01/14, 12:3744