Panasonic SL-SV572 Portable CD Player User Manual


 
The unit malfunctions when
connected to other equipment.
The remote control does
not work properly.
Cannot recharge.
The AC adaptor
becomes warm during
recharging.
The batteries are taking
a long time to recharge.
Play time is short after
recharging.
The battery indicator fails
to appear or is incorrect.
Radio reception is
noisy.
No sound from the
speakers.
No play.
No sound or there is a
lot of noise.
Play doesn’t resume from
the last point stopped.
Play doesn’t start from
the first track.
The unit stops working.
Cannot search through
tracks.
Cannot skip albums.
Cannot change the Digital Re-
master mode, anti-skip mode.
Digital Re-master does
not work.
1
RQT7211-B
F0204TR0
Matsushita Electric Industrial Co., Ltd.
Web Site: http://www.panasonic.co.jp/global/
GNEB EG
p
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
Troubleshooting guide
YC GC
GS
References to the remote control apply only to SL-SV572.
Display
The HOLD function is on. Release HOLD (page 5).
The batteries may have run empty (
page 5).
(If play is extremely short even after fully recharging the batteries,
the batteries may have exceeded their life. Rechargeable batteries
can be recharged approximately 300 times.)
The disc isn’t correctly set.
The disc is scratched or dirty. (Tracks skipped.)
There is moisture on the lens. Wait for about an hour and then try again.
The lens is dirty: clean it with a blower (recommended
product: SZZP1038C). If the lens gets marked with
fingerprints, gently wipe them off with a cotton swab.
The unit may not read MP3 correctly if it is shaken while it is reading the files.
Play of a multi-session disc may not be possible if there is a
blank data segment between sessions.
If there is large JPEG data etc. within a MP3 file, sound may
become muted and play may not be possible.
If you try playing a CD that contains CD-ROM format data and
normal audio data (CD-DA), output from one of the above
may become silent, and play may not be possible.
Ensure the plugs are inserted firmly.
Wipe the plugs clean with a clean cloth.
Noise may occur when playing MP3 if recording quality is poor.
The elapsed playing time disappears and sound is interrupted if
bumps continue repeatedly.
This doesn’t work if you change discs.
This doesn’t work during random play.
It may not work correctly under some conditions.
Random play modes may be on (
page 6).
Play resumes from the last point stopped (
above).
Disconnect then reconnect all power sources
(batteries and AC adaptor).
You cannot search through MP3 files.
You cannot skip between the first and last albums during play.
If [:]or [9] is pressed before [MEMORY/RECALL] you
cannot change the mode.
Depending on the type of MP3 disc recording, the effect may
not appear.
The HOLD function is on. Release HOLD (page 5).
You haven’t inserted a disc or it isn’t inserted correctly.
You have inserted a disc this unit cannot play.
The disc lid is open.
The program already contains 20 tracks.
Reading MP3 files.
Be sure to connect other equipment through the remote
control. Speakers connected directly to the unit should have an
impedance of 1 kor less.
Use only the included remote control to operate this unit.
You aren’t using the special rechargeable batteries (
page 5).
You must insert two batteries before you can recharge them.
The unit must be off before you can recharge.
This is normal.
The batteries may take a maximum of 6 hours to recharge
under some conditions.
This may occur after the first time you recharge the batteries or haven’t used
them for a long time. Play time should be restored after a few recharges.
The batteries can go flat if you leave the AC adaptor
connected after recharging is complete.
The indicator does not appear when the AC adaptor is connected.
The indicator does not appear correctly under some conditions.
Keep the unit away from other tuners and televisions.
The AM antenna is in the unit, so noise may increase if you hold the unit.
Connect the AC adaptor. The speakers do not work if you are
using only the batteries.
Make sure the plug is fully inserted.
SL-SV572
(
)
*
'
Operating Instructions
Portable CD Player
SL-J610V
SL-SV572
SL-SV570
Dear Customer
Thank you for purchasing this product.
Before connecting, operating or adjusting
this product, please read these
instructions completely. Please keep this
manual for future reference.
Note:
“EB” on the packaging indicates the
United Kingdom.
The SL-J610V and SL-SV570 models are
not designed for use with a remote control.
Playing MP3
This unit can play MP3 files you have recorded to discs.
MPEG Layer-3 audio decoding technology licensed from
Fraunhofer IIS and Thomson multimedia.
HOLD
This function causes the unit to ignore accidental button
presses.
Set to HOLD so the unit doesn’t power on accidentally or
interrupt play.
µ
The unit and remote control each have independent HOLD
switches.
Note on CD-R and CD-RW
This unit can play CD-R and CD-RW recorded with CD-DA or
MP3. Use an audio recording disc for CD-DA and finalize
§
it
when you finish recording. The unit may not be able to play
some discs due to the condition of the recording.
§A process performed after recording that enables
CD-R/CD-RW players to play audio CD-R and CD-RW.
Resume function
Play begins from the last point stopped. Replacing the disc
cancels the function.
Auto off function
If the unit is left in stop mode for approximately 10 minutes,
the unit turns itself off automatically.
SL-J610V