Filter
Top Products
18
RQT9754
To check the Wi-Fi signal strength where the unit is
located.
Preparation
Connect this unit to the wireless network. (l 8)
1 Press [SETUP] repeatedly to select
“SIG.LEVEL” and then press [OK].
≥ The unit’s display shows “LEVEL ”.
(“ ” stands for a number.)
2 Press [OK] to exit this display mode.
≥ It is recommended to have a signal strength of “3”.
Change the position or angle of your wireless network
router or the unit if the indication is “2” or “1” and see if
the connection improves.
≥ If “LEVEL 0” is displayed, this unit cannot establish a link
with the wireless network router. (l 21)
≥ This function does not work when “D.CONNECT” is set
to “ON”.
This unit can turn on automatically from standby
mode when this unit is selected as the AirPlay
speakers.
Preparation
Connect this unit to the wireless network. (l 8)
1 Press [SETUP] repeatedly to select
“NET STNBY” and then press [OK].
2 Press [3, 4] to select “ON” and then press
[OK].
≥ To cancel this function, select “OFF” in step 2.
≥ The factory preset is “OFF”. If this function is set to “ON”
the standby power consumption will increase.
Display the name for the connected wireless
network (SSID).
1 Press and hold [– NETWORK SETUP] on the
unit and [OK] on the remote control until the
unit's display shows the SSID.
2 Press [OK] to exit.
≥ If “NOCONNECT” is displayed this unit is not connected
to a wireless network.
≥ All letters are displayed as capital letters, and characters
that cannot be displayed are replaced with “¢”.
To check the unit’s IP address or the Wi-Fi MAC
address.
1 Press and hold [– NETWORK SETUP] on the
unit and [4] on the remote control until the
unit’s display shows the IP address.
{. The IP address is partially displayed.
≥ To display the MAC address on the unit, repeat the
steps above by replacing [4] with [3].
2 Press [3, 4] on the remote control to show the
rest of the IP address.
≥ To exit the setting, wait 20 sec.
≥ The “ – ” displayed on the top or bottom left of the display
indicate the first and last units respectively.
Wi-Fi signal strength
Network standby
Wireless network name (SSID)
IP/MAC Address
SC-HC58~RQT9754.book Page 18 Tuesday, December 18, 2012 4:40 PM