Filter
Top Products
12
DEUTSCH
ITALIANO
ESPAÑOL
1
Connect the AC adaptor to the
DC IN jack of the recharger
stand.
÷ Install the recharger stand on a
level surface.
÷ Keep the recharging terminals and
battery terminals always clean.
2 Connect the AC adaptor to
the household wall outlet.
÷ Disconnect the AC adapter
from the wall outlet when the
recharger stand is not used.
DC IN
Preparation of the recharger stand
1
Loading the batteries.
Rechargeable battery operation
(DPC-X937/DPC-X637 only)
Always use the specially provided rechargeable battery or a separately purchased NB-3A70. Never use a battery
other than a battery authorized by Kenwood.
Charge the battery with the power to the unit turned off. (The battery is not charged while the unit is in operation.)
1 Push the 0 PUSH OPEN key and open
the top cover.
2 Open the battery cover.
3 Insert 2 rechargeable
batteries and close the
cover.
÷ Make sure the positive ª and
negative · poles are properly
aligned.
Never use an alkaline battery and the
rechargeable battery together.
2
1
1
2
÷ A small amount of power is used even when the
unit is turned OFF. If the unit is not used for a long
time, therefore, remove the battery and store it in a
safe place.
÷ During battery charging or use of the unit, the battery
may become warm. This is normal and does not indi-
cate a malfunction.
*5378_08_15EN 03.7.3, 2:11 PM12